Version 7.2 287 Mediant 1000B Gateway & E-SBC
User's Manual 15. Services
Parameter Description
Note: The parameter is applicable only if the connection protocol
is HTTPS (defined using the 'Protocol' parameter, above).
15.6.4 Configuring HTTP Proxy Services
The HTTP Proxy Services table lets you configure up to 10 HTTP Proxy Services.
The following procedure describes how to configure HTTP Proxy Services through the Web
interface. You can also configure it through ini file (HTTPProxyService) or CLI (configure
network > http-proxy http-proxy-serv).
To configure an HTTP Proxy Service:
1. Open the HTTP Proxy Services table (Setup menu > IP Network tab > HTTP Proxy
folder > HTTP Proxy Services).
2. Click New; the following dialog box appears:
Figure 15-50: HTTP Proxy Services Table - Add Dialog Box
3. Configure an HTTP Proxy service according to the parameters described in the table
below.
4. Click Apply, and then save your settings to flash memory.
Table 15-21: HTTP Proxy Services Table Parameter Descriptions
Parameter Description
Index
[HTTPProxyService_Index]
Defines an index number for the new table row.
Note:
Each row must be configured with a unique index.
The parameter is mandatory.
Name
service-name
[HTTPProxyService_ServiceName]
Defines a descriptive name, which is used when associating
the row in other tables.
The valid value is a string of up to 40 characters. By default,
no value is defined.
Note:
Each row must be configured with a unique name.
To Next Page
Loading...
