AudioCodes Mediant 1000B - Viewing Registration Status

User's Manual 898 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
54.4 Viewing Registration Status
You can view the registration status of the device's endpoints (FXS, FXO and BRI) and SIP
Accounts. The registration mode (i.e., per device, endpoint, account. or no registration) is
configured in the Trunk Group Settings table (see Configuring Trunk Group Settings on
page 505) or using the TrunkGroupSettings ini file parameter.
 To view registration status:
 Open the Registration Status table (Monitor menu > Monitor tab > VoIP Status
folder > Registration Status).
Table 54-4: Registration Status Table Description
Parameter Description
Registered Per Gateway Registration status of the device as one entity:
 "YES"
 "NO"
Note: The parameter is applicable only to the Gateway
application.
Ports Registration Status Displays the registration status per analog (FXS or FXO)
port:
 "REGISTERED"
 "NOT REGISTERED"
Accounts Registration Status
Displays the status registration per Account, as configured in
the Accounts table (see ''Configuring Registration Accounts''
on page 383).
 Group Type: Served Trunk Group or IP Group
 Group Name: Name of served Trunk Group or IP Group,
if applicable

Status:
"REGISTERED" or "NOT REGISTERED"
Phone Number Status Displays the registration status of BRI endpoints:
 Phone Number: Phone number of endpoint.
 Gateway Port: module/port number of endpoint.
 Status: "REGISTERED" or "NOT REGISTERED"