AudioCodes Mediant 1000B - Direct Inward Dialing Parameters

Version 7.2 1149 Mediant 1000B Gateway & E-SBC
User's Manual 65. Configuration Parameters Reference
Parameter Description
number 911 when the phone connected to Port 1 of Module 1 is off-hooked
for over 10 seconds:
TargetOfChannel 0 = 911, 1, 1, 1,10;
Note:
 The first index of this table ini file parameter is 0.
 TargetOfChannel_Module is the module number, where 1 denotes the
module in Slot 1.
 TargetOfChannel_Port is the port number, where 1 denotes Port 1 on
the module.
 This is parameter is applicable only to FXS and FXO interfaces.
 For more information, see ''Configuring Automatic Dialing'' on page 621.
65.10.5.12 Direct Inward Dialing Parameters
The Direct Inward Dialing (DID) parameters are described in the table below.
Table 65-53: DID Parameters
Parameter Description
DID Wink
configure voip > sip-
definition settings > did-
wink-enbl
[EnableDIDWink]
Global parameter enabling Direct Inward Dialing (DID) using Wink-Start
signaling, typically used for signaling between an E-911 switch and the
PSAP.
You can also configure the functionality per specific calls, using Tel
Profiles (TelProfile_EnableDIDWink). For a detailed description of the
parameter and for configuring the functionality in th
e Tel Profiles table, see
''Configuring Tel Profiles'' on page 459.
Note:
 The parameter is applicable to FXS and FXO interfaces.
 If the functionality is configured for a specific Tel Profile, the settings of
the global parameter is ignored for calls associated with the Tel Profile.
configure voip > sip-
definition settings > time-
between-did-winks
[TimeBetweenDIDWinks]
Defines the interval (in msec) for wink signaling:
 Double-wink signaling [2]: interval between the first and second wink
 Wink and Polarity signaling [3]: interval between wink and polarity
change
The valid range is 100 to 2000. The default is 1000.
Note: See the EnableDIDWink parameter for configuring the wink
signaling type.
Delay Before DID Wink
configure voip > sip-
definition settings >
delay-b4-did-wink
[DelayBeforeDIDWink]
Defines the time interval (in msec) between the detection of the off-hook
and the generation of the DID Wink.
The valid range is 0 to 1,000. The default is 0.
Note: The parameter is applicable only to FXS interfaces.
NTT-DID-signaling-form
[NTTDIDSignallingForm]
Determines the type of DID signaling support for NTT (Japan) modem:
DTMF- or Frequency Shift Keying (FSK)-based signaling. The devices can
be connected to Japan's NTT PBX using 'Modem' DID lines. These DID
lines are used to deliver a called number to the PBX.
 [0] = (Default) FSK-based signaling

[1]
= DTMF-based signaling