AudioCodes Mediant 1000B User Manual

User's Manual 1036 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Parameter Description
For more information, see Customizing CDRs for SBC Calls on page
939.
65.3.4 Resource Allocation Indication Parameters
The Resource Allocation Indication (RAI) parameters are described in the table below.
Table 65-21: RAI Parameters
Parameter Description
[EnableRAI]
Enables Resource Available Indication (RAI) alarm generation if the
device's busy endpoints exceed a user-defined threshold, configured by
the RAIHighThreshold parameter. When enabled and the threshold is
crossed, the device sends the SNMP trap, acBoardCallResourcesAlarm.
 [0] = (Default) Disable
 [1] = Enable
Note: For the parameter to take effect, a device reset is required.
[RAIHighThreshold]
Defines the high threshold percentage of total calls that are active (busy
endpoints). When the percentage of the device's busy endpoints
exceeds this high threshold, the device sends the SNMP
acBoardCallResourcesAlarm alarm trap with a 'major' alarm status.
The range is 0 to 100. The default is 90.
Note: The percentage of busy endpoints is calculated by dividing the
number of busy endpoints by the total number of “enabled” endpoints
(trunks are physically connected and synchronized with no alarms and
endpoints are defined in the Trunk Group table).
[RAILowThreshold]
Defines the low threshold percentage of total calls that are active (busy
endpoints).
When the percentage of the device's busy endpoints falls below this low
threshold, the device sends an SNMP acBoardCallResourcesAlarm
alarm trap with a 'cleared' alarm status.
The range is 0 to 100%. The default is 90%.
[RAILoopTime]
Defines the time interval (in seconds) that the device periodically checks
call resource availability.
The valid range is 1 to 200. The default is 10.
65.4 Security Parameters
This subsection describes the device's security parameters.
65.4.1 General Security Parameters
The general security parameters are described in the table below.
Table 65-22: General Security Parameters
Parameter Description

AudioCodes Mediant 1000B Specifications

General

Brand	AudioCodes
Model	Mediant 1000B
Category	Gateway
Language	English