AudioCodes Mediant 1000B - Gateway Application Parameters; Fax and Modem Parameters

Version 7.2 1107 Mediant 1000B Gateway & E-SBC
User's Manual 65. Configuration Parameters Reference
Parameter Description
SBC RTCP XR Report Mode
configure voip > sip-definition
settings > sbc-rtcpxr-report-mode
[SBCRtcpXrReportMode]
Enables the sending of RTCP XR reports of QoE metrics at
the end of each call session (i.e., after a SIP BYE). The RTCP
XR is sent in the SIP PUBLISH message.
 [0] Disable (default)
 [1] End of Call
Note: The parameter is applicable only to the SBC application.
65.10 Gateway Application Parameters
65.10.1 Fax and Modem Parameters
The fax and modem parameters are described in the table below.
Table 65-38: Fax and Modem Parameters
Parameter Description
Fax Transport Mode
configure voip > media fax-
modem > fax-transport-mode
[FaxTransportMode]
Determines the fax transport mode used by the device.
 [0] Disable = transparent mode
 [1] T.38 Relay (default)
 [2] Bypass
 [3] Events Only
Note: The parameter is overridden by the parameter IsFaxUsed. If
the parameter IsFaxUsed is set to 1 (T.38 Relay) or 3 (Fax Fallback),
then FaxTransportMode is always set to 1 (T.38 relay).
V.21 Modem Transport Type
configure voip > media fax-
modem > V21-modem-
transport-type
[V21ModemTransportType]
Determines the V.21 modem transport type.
 [0] Disable = (Default) Transparent.
 [2] Enable Bypass
 [3] Events Only = Transparent with Events.
Note: You can also configure this functionality per specific calls,
using IP Profiles (IpProfile_VxxTransportType). For more
information, see ''Configuring IP Profiles'' on page 423.
V.22 Modem Transport Type
configure voip > media fax-
modem > V22-modem-
transport-type
[V22ModemTransportType]
Determines the V.22 modem transport type.
 [0] Disable = Transparent.
 [2] Enable Bypass (default)
 [3] Events Only = Transparent with Events.
Note: You can also configure this functionality per specific calls,
using IP Profiles (IpProfile_VxxTransportType). For more
information, see ''Configuring IP Profiles'' on page 423.
V.23 Modem Transport Type
configure voip > media fax-
modem > V23-modem-
transport-type
[V23ModemTransportType]
Determines the V.23 modem transport type.
 [0] Disable = Transparent.
 [2] Enable Bypass (default)
 [3] Events Only = Transparent with Events.
Note: You can also configure this functionality per specific calls,
using IP Profiles (IpProfile_VxxTransportType). For more
information, see ''Configuring IP Profiles'' on page 423.