AudioCodes Mediant 1000B - Supplementary Services

Version 7.2 1251 Mediant 1000B Gateway & E-SBC
User's Manual 65. Configuration Parameters Reference
Parameter Description
page 735.
Dial Plan Rule Table
Dial Plan Rule
configure voip > sbc dial-plan-
rule
[DialPlanRule]
Defines the dial plan rules per Dial Plan.
For more information, see ''Configuring Dial Plans'' on
page 735.
Note:
 The table is hidden in the ini file.
 To configure Dial Plan rules from a file, see
''Importing and Exporting Dial Plans'' on page 740.
Malicious Signature Table
Malicious Signature
configure voip > sbc malicious-
signature-database
[MaliciousSignatureDB]
Defines the malicious signature patterns
The format of the ini file table parameter is as follows:
[ MaliciousSignatureDB ]
FORMAT MaliciousSignatureDB_Index =
MaliciousSignatureDB_Name,
MaliciousSignatureDB_Pattern;
[ \MaliciousSignatureDB ]
For more information, see ''Configuring Malicious
Signatures'' on page 751.
65.11.1 Supplementary Services
The SBC and CRP supplementary services parameters are described in the table below.
Table 65-72: SBC and CRP Supplementary Services Parameters
Parameter Description
Emergency Call Preemption Parameters
For more information on SBC emergency call preemption, ''Configuring Call Preemption for SBC
Emergency Calls'' on page 753.
SBC Preemption Mode
configure voip > sbc settings >
sbc-preemption-mode
[SBCPreemptionMode]
Enables SBC emergency call preemption.
 [0] Disable (default)
 [1] Enable
Emergency Message Condition
configure voip > sbc settings >
sbc-emerg-condition
[SBCEmergencyCondition]
Defines the index of the Message Condition rule in the Message
Conditions table that is used to identify emergency calls.
Note: The device applies the rule only after call classification
(but before inbound manipulation).
Emergency RTP DiffServ
configure voip > sbc settings >
sbc-emerg-rtp-diffserv
[SBCEmergencyRTPDiffServ]
Defines DiffServ bits sent in the RTP for SBC emergency calls.
The valid value is 0 to 63. The default is 46.
Emergency Signaling DiffServ
configure voip > sbc settings >
Defines DiffServ bits sent in SIP signaling messages for SBC
emergency calls. This is included in the SIP Resource-Priority
header.