AudioCodes Mediant 1000B - Automatic Update Parameters

User's Manual 1012 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Parameter Description
For the ini file, the name must be enclosed by single apostrophes, for
example, 'cas_us.dat'.
Note: For the parameter to take effect, a device reset is required.
Dial Plan
[CasTrunkDialPlanName_x]
Defines the Dial Plan name (up to 11-character strings) per trunk.
For the ini file, the name must be enclosed by single apostrophes, for
example, 'dial_plan_2.dat'.
Note: The x in the ini file parameter name denotes the trunk number,
where 0 is Trunk 1.
Dial Plan File
[DialPlanFileName]
Defines the name of the Dial Plan file. This file should be created
using AudioCodes DConvert utility (refer to DConvert Utility User's
Guide).
For the ini file, the name must be enclosed by single apostrophes, for
example, 'dial_plan.dat'.
[UserInfoFileName] Defines the name of the file containing the User Information data.
For the ini file, the name must be enclosed by single apostrophes, for
example, 'userinfo_us.dat'.
65.1.8 Automatic Update Parameters
The automatic update of software and configuration files parameters are described in the
table below.
Table 65-8: Automatic Update of Software and Configuration Files Parameters
Parameter Description
General Automatic Update Parameters
CLI path: configure system > automatic-update
update-firmware
[AutoUpdateCmpFile]
Enables the Automatic Update mechanism for the cmp file.
 [0] = (Default) The Automatic Update mechanism doesn't apply to
the cmp file.
 [1] = The Automatic Update mechanism includes the cmp file.
Note: For the parameter to take effect, a device reset is required.
update-frequency
[AutoUpdateFrequency]
Defines the interval (in minutes) that the device waits between
consecutive automatic updates.
The default is 0 (i.e., the update at fixed intervals mechanism is
disabled).
Note: For the parameter to take effect, a device reset is required.
predefined-time
[AutoUpdatePredefinedTime]
Defines schedules (time of day) for performing automatic updates.
The format syntax of the parameter is 'hh:mm', where hh denotes the
hour and mm the minutes. The value must be enclosed in single
apostrophes. For example, '20:18'.
Note:
 For the parameter to take effect, a device reset is required.
 The actual update time is randomized by five minutes to reduce
the load on the Web servers.
http-user-agent Defines the information sent in the HTTP User-Agent header in the