AudioCodes Mediant 1000B - LDAP Parameters

User's Manual 1260 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Parameter Description
settings > local-cache-mode
[RadiusLocalCacheMode]
server).
 [0] Absolute Expiry Timer = When you access a Web page, the
timeout doesn't reset, instead it continues decreasing.
 [1] Reset Timer Upon Access = (Default) Upon each access to a
Web page, the timeout always resets (reverts to the initial value
configured by RadiusLocalCacheTimeout).
Password Local Cache
Timeout
configure system > radius
settings > local-cache-
timeout
[RadiusLocalCacheTimeout]
Defines the time (in seconds) the locally stored username and
password (verified by the RADIUS server) are valid. When this time
expires, the username and password become invalid and a must be re-
verified with the RADIUS server.
The valid range is 1 to 0xFFFFFF. The default is 300 (5 minutes).
 [-1] = Never expires.
 [0] = Each request requires RADIUS authentication.
RADIUS VSA Access Level
Attribute
configure system > radius
settings > vsa-access-level
[RadiusVSAAccessAttribute]
Defines the code that indicates the access level attribute in the Vendor
Specific Attributes (VSA) section of the received RADIUS packet.
The valid range is 0 to 255. The default is 35.
RADIUS Servers Table
RADIUS Servers
configure system >
radius servers
[RadiusServers]
Defines RADIUS servers.
The format of the ini file table parameter is as follows:
[ RadiusServers ]
FORMAT RadiusServers_Index = RadiusServers_ServerGroup,
RadiusServers_IPAddress, RadiusServers_AuthenticationPort,
RadiusServers_AccountingPort, RadiusServers_SharedSecret;
[ \RadiusServers ]
For a detailed description of this table, see ''Configuring RADIUS
Servers'' on page 232.
65.13.1.3 LDAP Parameters
The Lightweight Directory Access Protocol (LDAP) parameters are described in the table
below.
Table 65-76: LDAP Parameters
Parameter Description
LDAP Service
configure system > ldap settings >
ldap-service
[LDAPServiceEnable]
Enables the LDAP feature.
 [0] Disable (default)
 [1] Enable
Note: For the parameter to take effect, a device reset is
required.
LDAP Authentication Filter
configure system > ldap settings >
auth-filter
[LDAPAuthFilter]
Defines the LDAP search filter attribute for searching the
login username in the directory's subtree for LDAP-based
user authentication and authorization.
You can use the dollar ($) sign to represent the username.
For example, if the parameter is set to