AudioCodes Mediant 1000B - Character Conversion Parameters

Version 7.2 1151 Mediant 1000B Gateway & E-SBC
User's Manual 65. Configuration Parameters Reference
Parameter Description
[SuppServCodeCFUDeact]
Call Forward on Busy
configure voip >
gateway dtmf-supp-
service supp-service-
settingscfb-code
[SuppServCodeCFB]
Defines the prefix code for activating Call Forward on Busy sent to the
softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., ‘*72’).
Call Forward on Busy
Deactivation
configure voip >
gateway dtmf-supp-
service supp-service-
settingscfb-
deactivation-code
[SuppServCodeCFBDeact]
Defines the prefix code for deactivating Call Forward on Busy
Deactivation sent to the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., ‘*72’).
Call Forward on No Reply
configure voip >
gateway dtmf-supp-
service supp-service-
settingscfnr-code
[SuppServCodeCFNR]
Defines the prefix code for activating Call Forward on No Reply sent to
the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., ‘*72’).
Call Forward on No Reply
Deactivation
configure voip >
gateway dtmf-supp-
service supp-service-
settingscfnr-
deactivation-code
[SuppServCodeCFNRDeact]
Defines the prefix code for deactivating Call Forward on No Reply
Deactivation sent to the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., ‘*72’).
configure voip >
gateway dtmf-supp-
service supp-service-
settingsuse-facility-
in-req
[UseFacilityInRequest]
Enables the device to indicate the type of call forwarding service in the
Request-URI of the outgoing SIP INVITE message, using a proprietary
header parameter "facility=<call forward service>".
 [0] = (Default) Disable
 [1] = Enable
[BRICallForwardHandling]
Enables the device to handle BRI call forwarding.
 [0] Disable = (Defalt) BRI call forwarding is handled by a remote
server. The device interworks Facility message from the BRI
endpoint to SIP messages sent to the server. For more information,
see Remote Handling of BRI Call Forwarding on page 582.
 [1] Enable = BRI call forwarding is handled by the device. For more
information, see Local Handling of BRI Call Forwarding on page
584.
65.10.5.14 Character Conversion Parameters
The Character Conversion table parameter is described in the table below.