AudioCodes Mediant 1000B - User Information File for SBC User Database

Version 7.2 809 Mediant 1000B Gateway & E-SBC
User's Manual 44. Software Upgrade
44.1.8.3 User Information File for SBC User Database
You can use the SBC User Info table for the following:

Registering each user to an external registrar server.

Authenticating (for any SIP request and as a client) each user if challenged by an
external server.

Authenticating as a server incoming user requests (for SBC security).
If the device registers on behalf of users and the users do not perform registration, any SIP
request destined to the user is routed to the Proxy Set associated with the user’s IP Group.
You can configure up to 800 users (table rows) in the SBC User Info table. The SBC User
Info table can be configured using any of the following methods:

Web interface - see ''Configuring SBC User Info Table through Web Interface'' on
page
809

CLI - see Configuring SBC User Info Table through CLI on page 811

Loadable User Info file - see ''Configuring SBC User Info Table in Loadable Text File''
on page
811
44.1.8.3.1 Configuring SBC User Info Table through Web Interface
The following procedure describes how to configure the SBC User Info table through the
Web interface.
Note:
• To configure the User Info table, make sure that you have enabled the feature, as
described in Enabling the User Info Table on page 804.
• If you load any User Info file to the device, all previously configured entries are
removed from the table in the Web interface and replaced with the entries from the
loaded User Info file.
 To configure the SBC User Info table through the Web interface:
1. Open the SBC User Info table (Setup menu > Signaling & Media tab > SBC folder >
User Information).