AudioCodes Mediant 1000B - Configuring Remote HTTP Hosts

Version 7.2 277 Mediant 1000B Gateway & E-SBC
User's Manual 15. Services
Parameter Description
rest-ka-timeout
[HTTPRemoteServices_KeepAli
veTimeOut]
are sent. Keep-alive messages may be required for HTTP services
that expire upon inactive sessions.
The valid value is 0 to 65535. The default is 0 (i.e., no keep-alive
messages are sent).
Note: The parameter is applicable only if the 'Persistent
Connection' parameter (in the table) is configured to Enable.
15.5.1.1 Configuring Remote HTTP Hosts
The HTTP Remote Hosts table lets you configure up to 10 remote HTTP hosts per Remote
Web Service. The HTTP Remote Hosts table is a "child" of the Remote Web Services table
(configured in ''Configuring Remote Web Services'' on page 273).
The following procedure describes how to configure HTTP Remote hosts through the Web
interface. You can also configure it through ini file (HTTPRemoteServices) or CLI
(configure system > http-services > http-remote-hosts).
 To configure a remote HTTP host:
1. Open the Remote Web Services table (Setup menu > IP Network tab > Web
Services folder > Remote Web Services).
2. In the table, select the required remote Web service index row, and then click the
HTTP Remote Hosts link located below the table; the HTTP Remote Hosts table
appears.
3. Click New; the following dialog box appears:
Figure 15-41: HTTP Remote Hosts Table - Add Dialog Box
4. Configure an HTTP remote host according to the parameters described in the table
below.
5. Click Apply, and then save your settings to flash memory.