AudioCodes Mediant 1000B - SBC Parameters

User's Manual 1232 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Parameter Description
RedirectNumberMapIp2Tel_Prefix2Add,
RedirectNumberMapIp2Tel_Suffix2Add,
RedirectNumberMapIp2Tel_IsPresentationRestricted;
[\RedirectNumberMapIp2Tel]
For more information, see Configuring Redirect Number
Manipulation on page 551.
Redirect Number Tel-to-IP Table
Redirect Number Tel -> IP
configure voip > gateway
manipulation redirect-number-
map-tel2ip
[RedirectNumberMapTel2IP]
This table parameter manipulates the Redirect Number for Tel-to-
IP calls. The format of the ini file table parameter is as follows:
[RedirectNumberMapTel2Ip]
FORMAT RedirectNumberMapTel2Ip_Index =
RedirectNumberMapTel2Ip_ManipulationName,
RedirectNumberMapTel2Ip_DestinationPrefix,
RedirectNumberMapTel2Ip_RedirectPrefix,
RedirectNumberMapTel2Ip_NumberType,
RedirectNumberMapTel2Ip_NumberPlan,
RedirectNumberMapTel2Ip_RemoveFromLeft,
RedirectNumberMapTel2Ip_RemoveFromRight,
RedirectNumberMapTel2Ip_LeaveFromRight,
RedirectNumberMapTel2Ip_Prefix2Add,
RedirectNumberMapTel2Ip_Suffix2Add,
RedirectNumberMapTel2Ip_IsPresentationRestricted,
RedirectNumberMapTel2Ip_SrcTrunkGroupID;
[\RedirectNumberMapTel2Ip]
For more information, see ''Configuring Redirect Number
Manipulation'' on page 551.
Phone Contexts Table
Phone Contexts
configure voip > gateway
manipulation phone-context-
table
[PhoneContext]
Defines the Phone Context table. The parameter maps NPI and
TON to the SIP 'phone-context' parameter, and vice versa.
The format for the parameter is as follows:
[PhoneContext]
FORMAT PhoneContext_Index = PhoneContext_Npi,
PhoneContext_Ton, PhoneContext_Context;
[\PhoneContext]
For example:
PhoneContext 0 = 0,0,unknown.com
PhoneContext 1 = 1,1,host.com
PhoneContext 2 = 9,1,na.e164.host.com
For more information, see ''Configuring NPI/TON-SIP Phone-
Context Mapping Rules'' on page 557.
Add Phone Context As Prefix
configure voip > gateway
manipulation settings > add-ph-
cntxt-as-pref
[AddPhoneContextAsPrefix]
Determines whether the received Phone-Context parameter is
added as a prefix to the outgoing ISDN Setup message with (for
digital interfaces) Called and Calling numbers.
 [0] Disable (default)
 [1] Enable
65.11 SBC Parameters
The SBC and CRP parameters are described in the table below.