AudioCodes Mediant 1000B - Page 1233

Version 7.2 1233 Mediant 1000B Gateway & E-SBC
User's Manual 65. Configuration Parameters Reference
Table 65-71: SBC and CRP Parameters
Parameter Description
CRP-specific Parameters
CRP Application
configure voip > application > enable-crp
[EnableCRPApplication]
Enables the CRP application.
 [0] Disable (default)
 [1] Enable
Note: For the parameter to take effect, a device reset
is required.
CRP Survivability Mode
configure voip > sbc settings > crp-
survivability-mode
[CRPSurvivabilityMode]
Defines the CRP mode.
 [0] Standard Mode (default)
 [1] Always Emergency Mode
 [2] Auto-answer REGISTER
configure voip > sbc settings > crp-gw-
fallback
[CRPGatewayFallback]
Enables fallback routing from the proxy server to the
Gateway (PSTN).
 [0] = Disable (default)
 [1] = Enable
SBC-specific Parameters
Enable SBC
configure voip > application > enable-sbc
[EnableSBCApplication]
Enables the Session Border Control (SBC)
application.
 [0] Disable
 [1] Enable (default)
Note:
 For the parameter to take effect, a device reset is
required.
 The parameter is enabled by default only if the
License Key contains at least one of the SBC-
related capacity features (e.g., "SBC-Signaling");
otherwise, the parameter is disabled.
SBC and CRP Parameters
Unclassified Calls
configure voip > sbc settings > unclassified-
calls
[AllowUnclassifiedCalls]
Determines whether incoming calls that cannot be
classified (i.e. classification process fails) to a Source
IP Group are rejected or processed.
 [0] Reject = (Default) Call is rejected if
classification fails.
 [1] Allow = If classification fails, the incoming
packet is assigned to a source IP Group (and
subsequently processed) as follows:

The source SRD is determined according to
the SIP Interface to where the SIP-initiating
dialog request is sent. The source IP Group is
set to the default IP Group associated with this
SRD.

If the source SRD is ID 0, then source IP
Group ID 0 is chosen. In case of any other
SRD, then the first IP Group associated with
this SRD is chosen as the source IP Group or
the call. If no IP Group is associated with this
SRD, the call is rejected.