AudioCodes Mediant 1000B - Services; RADIUS and LDAP Parameters; General Parameters

Version 7.2 1257 Mediant 1000B Gateway & E-SBC
User's Manual 65. Configuration Parameters Reference
Parameter Description
configure voip > media ipmedia >
energy-detector-enable
[EnableEnergyDetector]
events (notifications) when the signal received from the PSTN
is higher or lower than a user-defined threshold (defined by the
EnergyDetectorThreshold parameter).
 [0] Disable (default)
 [1] Enable
Energy Detector Quality Factor
configure voip > media ipmedia >
energy-detector-sensitivity
[EnergyDetectorQualityFactor]
Defines the Energy Detector's sensitivity level.
The valid range is 0 to 10, where 0 is the lowest sensitivity and
10 the highest sensitivity. The default is 4.
Energy Detector Threshold
configure voip > media ipmedia >
energy-detector-threshold
[EnergyDetectorThreshold]
Defines the Energy Detector's threshold. A signal below or
above this threshold invokes an 'Above' or 'Below' event.
The threshold is calculated as follows:
Actual Threshold = -44 dBm + (EnergyDetectorThreshold * 6)
The valid value range is 0 to 7. The default is 3 (i.e., -26 dBm).
Pattern Detection Parameters
Note: For an overview on the pattern detector feature for TDM tunneling, see DSP Pattern Detector
on page 489.
Enable Pattern Detector
[EnablePatternDetector]
Enables the Pattern Detector (PD) feature.
 [0] Disable (default)
 [1] Enable
[PDPattern] Defines the patterns that can be detected by the Pattern
Detector.
The valid range is 0 to 0xFF.
Note: For the parameter to take effect, a device reset is
required.
[PDThreshold] Defines the number of consecutive patterns to trigger the
pattern detection event.
The valid range is 0 to 31. The default is 5.
Note: For the parameter to take effect, a device reset is
required.
65.13 Services
65.13.1 RADIUS and LDAP Parameters
65.13.1.1 General Parameters
The general RADIUS and LDAP parameters are described in the table below.
Table 65-74: General RADIUS and LDAP Parameters
Parameter Description
Use Local Users Database
configure system > mgmt-auth
Defines when the device uses the Local Users table or an
LDAP/RADIUS server for authenticating the login credentials