User's Manual 1218 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Parameter Description
Forking Timeout
configure voip > gateway advanced
> forking-timeout
[ForkingTimeOut]
Defines the timeout (in seconds) that is started after the first
SIP 2xx response has been received for a User Agent when a
Proxy server performs call forking (Proxy server forwards the
INVITE to multiple SIP User Agents). The device sends a SIP
ACK and BYE in response to any additional SIP 2xx received
from the Proxy within this timeout. Once this timeout elapses,
the device ignores any subsequent SIP 2xx.
The number of supported forking calls per channel is 20. In
other words, for an INVITE message, the device can receive
up to 20 forking responses from the Proxy server.
The valid range is 0 to 30. The default is 30.
Tel2IP Call Forking Mode
configure voip > sip-definition
settings > tel2ip-call-forking-mode
[Tel2IPCallForkingMode]
Enables Tel-to-IP call forking, whereby a Tel call can be
routed to multiple IP destinations.
[0] Disable (default)
[1] Enable
Note: Once enabled, routing rules must be assigned Forking
Groups in the Tel-to-IP Routing table.
configure voip > sip-definition
settings > forking-delay-time-invite
[ForkingDelayTimeForInvite]
Defines the interval (in seconds) to wait before sending
INVITE messages to the other members of the forking group.
The INVITE is immediately sent to the first member.
The valid value range is 0 to 40. The default is 0 (i.e., sends
immediately).
Routing Policies Table
Routing Policies
cconfigure voip > gateway routing
gw-routing-policy
[GWRoutingPolicy]
Edits the Routing Policy.
The format of the ini file table parameter is as follows:
[ GwRoutingPolicy ]
FORMAT GwRoutingPolicy_Index = GwRoutingPolicy_Name,
GwRoutingPolicy_LCREnable,
GwRoutingPolicy_LCRAverageCallLength,
GwRoutingPolicy_LCRDefaultCost,
GwRoutingPolicy_LdapServersGroupName;
[ \GwRoutingPolicy ]
For more information, see ''Configuring a Gateway Routing
Policy Rule'' on page 525.
65.10.13 IP Connectivity Parameters
The IP connectivity parameters are described in the table below.
Table 65-68: IP Connectivity Parameters
Parameter Description
Enable Alt Routing Tel to IP
configure voip > gateway routing
settings > alt-routing-tel2ip
[AltRoutingTel2IPEnable]
Enables the Alternative Routing feature for Tel-to-IP calls.
[0] Disable = (Default) Disables the Alternative Routing
feature.
[1] Enable = Enables the Alternative Routing feature.
[2] Status Only = The Alternative Routing feature is disabled,
but read-only information on the QoS of the destination IP
addresses is provided.
To Next Page
Loading...
