AudioCodes Mediant 1000B - OCSP Parameters; Quality of Experience Parameters

User's Manual 1044 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Parameter Description
IDS Match Table
[IDSMatch]
Defines target rules per IDS Policy.
The format of the ini file parameter is:
[ IDSMatch ]
FORMAT IDSMatch_Index = IDSMatch_SIPInterface,
IDSMatch_ProxySet, IDSMatch_Subnet, IDSMatch_Policy;
[ \IDSMatch ]
For more information, see ''Assigning IDS Policies'' on page 181.
65.4.7 OCSP Parameters
The Online Certificate Status Protocol (OCSP) parameters are described in the table
below.
Table 65-28: OCSP Parameters
Parameter Description
Enable OCSP Server
configure network > ocsp >
enable
[OCSPEnable]
Enables or disables certificate checking using OCSP.
 [0] Disable (default)
 [1] Enable
For a description of OCSP, see Configuring Certificate Revocation
Checking (OCSP).
Primary Server IP
configure network > ocsp >
server-ip
[OCSPServerIP]
Defines the IP address of the OCSP server.
The default IP address is 0.0.0.0.
Secondary Server IP
configure network > ocsp >
secondary-server-ip
[OCSPSecondaryServerIP]
Defines the IP address (in dotted-decimal notation) of the secondary
OCSP server (optional).
The default IP address is 0.0.0.0.
Server Port
configure network > ocsp >
server-port
[OCSPServerPort]
Defines the OCSP server's TCP port number.
The default port number is 2560.
Default Response When
Server Unreachable
configure network > ocsp >
default-response
[OCSPDefaultResponse]
Determines whether the device allows or rejects peer certificates
when the OCSP server cannot be contacted.
 [0] Reject (default)
 [1] Allow
65.5 Quality of Experience Parameters
The Quality of Experience (QoE) parameters are described in the table below.