AudioCodes Mediant 1000B - ISDN Parameters

Version 7.2 1163 Mediant 1000B Gateway & E-SBC
User's Manual 65. Configuration Parameters Reference
Parameter Description
[CASStateMachineGenerateDigit
OnTime]
The value must be a positive value. The default is -1.
Generate Inter Digit Time
[CASStateMachineGenerateInter
DigitTime]
Generates digit off-time (in msec).
The value must be a positive value. The default is -1.
DTMF Max Detection Time
[CASStateMachineDTMFMaxOn
DetectionTime]
Detects digit maximum on time (according to DSP detection
information event) in msec units.
The value must be a positive value. The default is -1.
DTMF Min Detection Time
[CASStateMachineDTMFMinOnD
etectionTime]
Detects digit minimum on time (according to DSP detection
information event) in msec units. The digit time length must be
longer than this value to receive a detection. Any number may be
used, but the value must be less than
CasStateMachineDTMFMaxOnDetectionTime.
The value must be a positive value. The default is -1.
MAX Incoming Address Digits
[CASStateMachineMaxNumOfInc
omingAddressDigits]
Defines the limitation for the maximum address digits that need to
be collected. After reaching this number of digits, the collection of
address digits is stopped.
The value must be an integer. The default is -1.
MAX Incoming ANI Digits
[CASStateMachineMaxNumOfInc
omingANIDigits]
Defines the limitation for the maximum ANI digits that need to be
collected. After reaching this number of digits, the collection of
ANI digits is stopped.
The value must be an integer. The default is -1.
Collect ANI
[CASStateMachineCollectANI]
In some cases, when the state machine handles the ANI
collection (not related to MFCR2), you can enable the state
machine to collect ANI or discard ANI.
 [0] No = Don't collect ANI.
 [1] Yes = Collect ANI.
 [-1] Default = Default value.
Digit Signaling System
[CASStateMachineDigitSignaling
System]
Defines which Signaling System to use in both directions
(detection\generation).
 [0] DTMF = DTMF signaling.
 [1] MF = (Default) MF signaling.
 [-1] Default = Default value.
65.10.6.4 ISDN Parameters
The ISDN parameters are described in the table below.
Table 65-59: ISDN Parameters
Parameter Description
ISDN Termination Side
configure voip > interface e1-t1|bri >
isdn-termination-side
[TerminationSide]
Determines the ISDN termination side.
 [0] User side = (Default) ISDN User Termination Equipment
(TE) side.
 [1] Network side = ISDN Network Termination (NT) side.
Note: Select 'User side' when the PSTN or PBX side is