AudioCodes Mediant 1000B - PSTN Parameters; General Parameters

User's Manual 1152 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Table 65-55: Char Conversion Table Parameters
Char Conversion Table
Char Conversion
configure voip > gateway
dtmf-supp-service dtmf-
and-dialing > char-
conversion
[CharConversion]
Defines Unicode-to-ASCII character conversion rules. The format of the
ini file table parameter is as follows:
[CharConversion]
FORMAT CharConversion_Index = CharConversion_CharName,
CharConversion_FirstByte, CharConversion_SecondByte,
CharConversion_ConvertedOutput;
[\CharConversion]
For more information, see ''Converting Accented Characters from IP to
Tel'' on page 615.
65.10.6 PSTN Parameters
This subsection describes the device's PSTN parameters.
65.10.6.1 General Parameters
The general PSTN parameters are described in the table below.
Table 65-56: General PSTN Parameters
Parameter Description
Trunk Name
config-voip > interface
<e1|t1|bri> name
[DigitalPortInfo_x]
Defines an arbitrary name for a trunk (where x denotes the trunk
number for the ini file parameter). This can be used to help you
easily identify the trunk.
The valid value is a string of up to 40 characters. The following
special characters can be used (without the quotes):
 " " (space)
 "." (period)
 "=" (equal sign)
 "-" (hyphen)
 "_" (underscore)
 "#" (pound sign)
By default, the value is undefined.
Protocol Type
configure voip > interface e1-
t1|bri > protocol
[ProtocolType]
Defines the PSTN protocol for all the Trunks. To configure the
protocol type for a specific Trunk, use the ini file parameter
ProtocolType_x:
 [0] NONE
 [1] E1 EURO ISDN = ISDN PRI Pan-European (CTR4)
protocol
 [2] T1 CAS = Common T1 robbed bits protocols including E&M
wink start, E&M immediate start, E&M delay dial/start and loop-
start and ground start.
 [3] T1 RAW CAS
 [4] T1 TRANSPARENT = Transparent protocol, where no
signaling is provided by the device. Timeslots 1 to 24 of all
trunks are mapped to DSP channels.
 [5] E1 TRANSPARENT 31 = Transparent protocol, where no
signaling is provided by the device. Timeslots 1 to 31 of each
trunk are mapped to DSP channels.