User's Manual 860 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Remove:"4"
Add: "0"
48.8 Remote Users Page
The Remote Users (FEU) wizard page configures the remote users settings.
Note: This page is applicable only to IP PBXs that support such configuration.
Figure 48-8: SBC Configuration Wizard - Remote Users Page
To configure remote users:
1. Select the 'Enable remote users' check box.
2. Under the SIP Interface group, configure the SIP interface for the remote users:
• 'Transport Type': Configure the SIP transport type.
• 'Listening Port': Configure the SIP port used by the device for communicating with
remote users. For One Port: LAN and One Port: WAN network topologies, you
must configure different listening ports for communication with the IP PBX and
remote users.
3. Under the Media Ports (Realm) group, configure the media protocol type and ports
used by the device for communicating with the remote users:
• 'Media Protocol': Configure the media protocol type (RTP or SRTP).
• 'Base Port': Configure the first media port.
To Next Page
Loading...
