AudioCodes Mediant 1000B - Call Waiting Parameters

User's Manual 1130 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Parameter Description
Where,
 Enable = accept [0] (default) or reject [1] incoming
anonymous calls.
 Port = Port number.
 Module = Module number.
For example:
RejectAnonymousCallPerPort 0 = 0,1,1;
RejectAnonymousCallPerPort 1 = 1,2,1;
Note: The parameter is applicable only to FXS interfaces.
65.10.5.2 Call Waiting Parameters
The call waiting parameters are described in the table below.
Table 65-43: Call Waiting Parameters
Parameter Description
Enable Call Waiting
configure voip > gateway dtmf-
supp-service supp-service-
settings > call-waiting
[EnableCallWaiting]
Enables the Call Waiting feature.
 [0] Disable
 [1] Enable (Default)
For digital interfaces: If enabled and the device initiates a Tel-to-
IP
call to a destination that is busy, it plays a call waiting ringback
tone to the caller. The tone is played only if the destination returns
a 182 "Queued" SIP response.
For FXS interface: If enabled, when an FXS interface receives a
call on a busy endpoint, it responds with a 182 response (and not
with a 486 busy). The device plays a call waiting indication signal.
When hook-flash is detected, the device switches to the waiting
call. The device that initiated the waiting call plays a call waiting
ringback tone to the calling party after a 182 response is received.
Note:
 The device's Call Progress Tones (CPT) file must include a
Call Waiting ringback tone (caller side) and a call waiting tone
(called side, FXS only).
 FXS interfaces: The EnableHold parameter must be enabled
on both the calling and the called side.
 Analog interfaces: You can use the table parameter
CallWaitingPerPort to enable Call Waiting per port.
 Analog interfaces: For information on the Call Waiting feature,
see Enabling Call Waiting on page 585.
configure voip > sip-definition
settings > send-180-for-call-
waiting
[Send180ForCallWaiting]
Determines the SIP response code for indicating Call Waiting.
 [0] = (Default) Use 182 Queued response to indicate call
waiting.

[1]
= Use 180 Ringing response to indicate call waiting.
Call Waiting Table
Call Waiting
configure voip > gateway analog
call-waiting
Defines call waiting per FXS port.
The format of the ini file table parameter is as follows:
[CallWaitingPerPort]
FORMAT CallWaitingPerPort_Index =