AudioCodes Mediant 1000B - RADIUS Parameters

User's Manual 1258 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Parameter Description
> use-local-users-db
[MgmtUseLocalUsersDatabase]
(username-password) of users when logging into the device's
management interface (e.g., Web or CLI).
 [0] When No Auth Server Defined = (Default) The device
authenticates the users using the Local Users table in the
following scenarios:

If no LDAP/RADIUS server is configured.

If an LDAP/RADIUS server is configured, but connectivity
with the server is down. If there is connectivity with the
server, the device uses the server to authenticate the user.
 [1] Always = The device first attempts to authenticate the user
using the Local Users table. If no user is found (based on the
username-password combination), it attempts to authenticate
the user using the LDAP/RADIUS server.
Behavior upon Authentication
Server Timeout
configure system > mgmt-auth
> timeout-behavior
[MgmtBehaviorOnTimeout]
Defines the device's response when a connection timeout occurs
with the LDAP/RADIUS server.
 [0] Deny Access = User is denied access to the management
platform.
 [1] Verify Access Locally = (Default) Device verifies the user's
credentials in its Local Users table (local database).
Note: The parameter is applicable to LDAP- and RADIUS-based
management-user login authentication.
Default Access Level
configure system > mgmt-auth
> default-access-level
[DefaultAccessLevel]
Defines the default access level for the device when the
LDAP/RADIUS response doesn't include an access level attribute
for determining the user's management access level.
The valid range is 0 to 255. The default is 200 (i.e., Security
Administrator).
Note: The parameter is applicable to LDAP- or RADIUS-based
management-user login authentication and authorization.
65.13.1.2 RADIUS Parameters
The RADIUS parameters are described in the table below.
Table 65-75: RADIUS Parameters
Parameter Description
General RADIUS Parameters
Enable RADIUS Access
Control
configure system > radius
settings > enable
[EnableRADIUS]
Enables the RADIUS application.
 [0] Disable (Default)
 [1] Enable
Note: For the parameter to take effect, a device reset is required.
[RadiusTrafficType] Defines the device's network interface for communicating (RADIUS
traffic) with the RADIUS server(s).
 [0] OAMP (default)
 [1] Control
Note: If set to Control, only one Control interface must be configured in