User's Manual 1264 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Parameter Description
For more information, see ''Configuring Time Bands for Cost Groups''
on page 271.
65.13.3 Call Setup Rules Parameters
The Call Setup Rules parameters are described in the table below.
Table 65-78: Call Setup Rules Parameters
Parameter Description
Call Setup Rules
configure voip > message
call-setup-rules
[CallSetupRules]
Defines Call Setup Rules that the device runs at call setup for LDAP-
based routing and other advanced routing logic requirements including
manipulation.
[ CallSetupRules ]
FORMAT CallSetupRules_Index = CallSetupRules_RulesSetID,
CallSetupRules_QueryType, CallSetupRules_QueryTarget,
CallSetupRules_AttributesToQuery, CallSetupRules_AttributesToGet,
CallSetupRules_RowRole, CallSetupRules_Condition,
CallSetupRules_ActionSubject, CallSetupRules_ActionType,
CallSetupRules_ActionValue;
[ \CallSetupRules ]
For more information, see ''Configuring Call Setup Rules'' on page 414.
65.13.4 HTTP-based Services
The HTTP-based service parameters are described in the table below.
Table 65-79: HTTP-based Service Parameters
Parameter Description
GW Routing Server
configure voip > gw routing
general-setting > gw-routing-
server
[GWRoutingServer]
Enables routing by a Routing server.
[0] Disable (default)
[1] Enable
For more information, see Centralized Third-Party Routing Server
on page 279.
Note: The parameter is applicable only to the Gateway
application.
Quality Status
configure system > http-
services > routing-qos-
status
[RoutingServerQualityStatus]
Enables QoS-based routing by the routing server. The device
collects QoS metrics (media and signaling) and sends them to the
routing server.
[0] Disable (default)
[1] Enable
For more information, see Configuring QoS-Based Routing by
Routing Server on page 282.
Quality Status Rate
configure system > http-
Defines the rate (in sec) at which the device sends QoS reports to
the routing server.
The valid range is 15-3600. The default is 60.
To Next Page
Loading...
