User's Manual 964 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Error Abbreviation Error Name Description
MR
Modem Relay Is Not Supported
OR
DSP JB Overrun
PH
Packet Header Error
PL
RTP Packet Loss
RB
Counts the number of BFI Frames Received From The Host
RD
No Available Release Descriptor
RO
RTP Reorder
RP
Unknown RTP Payload Type
RS
RTP SSRC Error
UF
Unrecognized Fax Relay Command
AA
Invalid Accumulated Packets Counter
AC
Invalid Channel ID
AL
Invalid Header Length
AO
Invalid Codec Type
AP
Unknown Aggregation Payload Type
AR
Invalid Routing Flag Received
58.2.1.2 Identifying AudioCodes Syslog Messages using Facility Levels
The device’s Syslog messages can easily be identified and distinguished from Syslog
messages from other equipment, by setting its Facility level. The Facility levels of the
device's Syslog messages are numerically coded with decimal values. Facility level may
use any of the "local use" facilities (0 through 7), according to RFC 3164. Implementing
Facility levels is useful, for example, if you collect the device’s as well as other equipments’
Syslog messages on the same server. Therefore, in addition to filtering Syslog messages
by IP address, you can filter messages by Facility level.
To configure the Facility level:
Configure the SyslogFacility ini file parameter to one of the following options:
Table 58-5: Syslog Facility Levels
Numerical Value Facility Level
16 (default)
local use 0 (local0)
17
local use 1 (local1)
18
local use 2 (local2)
19
local use 3 (local3)
20
local use 4 (local4)
21
local use 5 (local5)
22
local use 6 (local6)
To Next Page
Loading...
