AudioCodes Mediant 1000B - Call Setup Rule Examples

User's Manual 398 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Parameter Description

[2] Modify = Sets element to the new value (all element
types).
 [3] Add Prefix = Adds value at the beginning of the string
(string element only).
 [4] Add Suffix = Adds value at the end of the string (string
element only).
 [5] Remove Suffix = Removes value from the end of the
string (string element only).
 [6] Remove Prefix = Removes value from the beginning of
the string (string element only).
 [20] Run Rules Set = Performs a different Rule Set ID,
specified in the 'Action Value' parameter (below)
 [21] Exit = Stops the Rule Set ID and returns a result
("True" or "False"). .
Action Value
action-value
[CallSetupRules_ActionValue]
Defines a value that you want to use in the action.
The valid value is a string of up to 300 characters (case-
insensitive).
Examples:
 '+9723976'+ldap.attr.alternateNumber
 '9764000'
 srctags
 ldap.attr.displayName
 true (if the 'Action Type' is set to Exit)
 false (if the 'Action Type' is set to
Exit
)
18.3.1 Call Setup Rule Examples
Below are configuration examples for using Call Setup Rules.
 Example 1: This example configures the device to replace (manipulate) the incoming
call's source number with a number retrieved from the AD by an LDAP query. The
device queries the AD server for the attribute record, "telephoneNumber" whose value
is the same as the received source number (e.g., "telephoneNumber =4064"). If such
an attribute is found, the device retrieves the number of the attribute record,
"alternateNumber" and uses this number as the source number.
• Call Setup Rules table configuration:
♦ 'Rules Set ID': 1
♦ 'Query Type': LDAP
♦ 'Query Target': LDAP-DC-CORP
♦ 'Search Key': ‘telephoneNumber=’ + param.call.src.user
♦ 'Attributes to Get': alternateNumber
♦ 'Row Role': Use Current Condition
♦ 'Condition': ldap.attr. alternateNumber exists
♦ 'Action Subject': param.call.src.user
♦ 'Action Type': Modify
♦ 'Action Value': ldap.attr. alternateNumber
• Routing table configuration: A single routing rule is assigned the Call Setup
Rule Set ID.