AudioCodes Mediant 1000B - Page 397

Version 7.2 397 Mediant 1000B Gateway & E-SBC
User's Manual 18. SIP Definitions
Parameter Description
row-role
[CallSetupRules_RowRole]
be performed.
 [0] Use Current Condition = The Condition configured for
this rule must be matched in order to perform the configured
action (default).
 [1] Use Previous Condition = The Condition configured for
the rule located directly above this rule in the Call Setup
table must be matched in order to perform the configured
action. This option lets you configure multiple actions for the
same Condition.
Condition
condition
[CallSetupRules_Condition]
Defines the condition that must exist for the device to perform
the action.
The valid value is a string of up to 200 characters (case-
insensitive). Regular Expression (regex) can also be used.
Examples:
 LDAP:

ldap.attr.mobile exists (if Attribute "mobile" exists in AD)

param.call.dst.user == ldap.attr.msRTCSIP-PrivateLine
(if called number is the same as the number in the
Attribute "msRTCSIP-PrivateLine")

ldap.found !exists (if LDAP record not found)

ldap.err exists (if LDAP error exists)
 Dial Plan:

dialplan.found exists (if Dial Plan exists)

dialplan.found !exists (if Dial Plan query search key not
found)
 dialplan.result=='uk' (if corresponding tag of the searched
key is "uk")
Action
Action Subject
action-subject
[CallSetupRules_ActionSubject]
Defines the element (header, parameter, body, or Dial Plan
tag) upon which you want to perform the action if the condition,
configured in the 'Condition' parameter (see above) is met.
The valid value is a string of up to 100 characters (case-
insensitive).
Examples:
 header.from contains '1234'
 param.call.dst.user (called number)
 param.call.src.user (calling number)
 param.call.src.name (calling name)
 param.call.redirect (redirect number)
 param.call.src.host (source host)
 param.call.dst.host (destination host)
 srctags (source tag)
 dsttags (destination tag)
Action Type
action-type
[CallSetupRules_ActionType]
Defines the type of action to perform.
 [0] Add (default) = Adds new message header, parameter
or body elements.
 [1] Remove = Removes message header, parameter, or
body elements.