AudioCodes Mediant 1000B - SSH Parameters

User's Manual 1042 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Parameter Description
[TLSExpiryCheckPeriod]
The valid value is 1 to 3650. The default is 7.
65.4.5 SSH Parameters
Secure Shell (SSH) parameters are described in the table below.
Table 65-26: SSH Parameters
Parameter Description
Enable SSH Server
configure system > cli-settings
> ssh
[SSHServerEnable]
Enables the device's embedded SSH server.
 [0] Disable (default)
 [1] Enable
Server Port
configure system > cli-settings
> ssh-port
[SSHServerPort]
Defines the port number for the embedded SSH server.
Range is any valid port number. The default port is 22.
SSH Admin Key
configure system > cli-settings
> ssh-admin-key
[SSHAdminKey]
Defines the RSA public key for strong authentication for logging in
to the SSH interface (if enabled).
The value should be a base64-encoded string. The value can be a
maximum length of 511 characters.
Note: The parameter is overridden by the SSH public key
configured for a specific management user in the Local Users table
(see Configuring Management User Accounts on page 74).
Public Key
configure system > cli-settings
> ssh-require-public-key
[SSHRequirePublicKey]
Enables RSA public keys for SSH.
 [0] Disable = (Default) RSA public keys are optional if a value is
configured for the parameter SSHAdminKey.
 [1] Enable = RSA public keys are mandatory.
Note: To define the key size, use the TLSPkeySize parameter.
Max Payload Size
ssh-max-payload-size
[SSHMaxPayloadSize]
Defines the maximum uncompressed payload size (in bytes) for
SSH packets.
The valid value is 550 to 32768. The default is 32768.
Max Binary Packet Size
configure system > cli-settings
> ssh-max-binary-packet-size
[SSHMaxBinaryPacketSize]
Defines the maximum packet size (in bytes) for SSH packets.
The valid value is 582 to 35000. The default is 35000.
Maximum SSH Sessions
configure system > cli-settings
> ssh-max-sessions
[SSHMaxSessions]
Defines the maximum number of simultaneous SSH sessions.
The valid range is 1 to 5. The default is 5.
Enable Last Login Message
configure system > cli-settings
> ssh-last-login-message
[SSHEnableLastLoginMessage]
Enables message display in SSH sessions of the time and date of
the last SSH login. The SSH login message displays the number of
unsuccessful login attempts since the last successful login.
 [0] Disable
 [1] Enable (default)
Note: The last SSH login information is cleared when the device is