AudioCodes Mediant 1000B - Tone Detection Parameters

User's Manual 1200 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Parameter Description
SendISDNTransferOnConnect is set to 1.
 The parameter is applicable only to digital interfaces.
MFC R2 Category
mfcr2-category
[R2Category]
Defines the tone for MFC R2 calling party category (CPC). The
parameter provides information on the calling party such as
National or International call, Operator or Subscriber and
Subscriber priority.
The value range is 1 to 15 (defining one of the MFC R2 tones).
The default is 1.
Note: The parameter is applicable only to digital interfaces.
Tone Index Table
Tone Index
configure voip > gateway analog
tone-index
[ToneIndex]
Defines distinctive ringing and call waiting tones per FXS
endpoint (or for a range of FXS endpoints).
The format of the ini file table parameter is as follows:
[ToneIndex]
FORMAT ToneIndex_Index = ToneIndex_FXSPort_First,
ToneIndex_FXSPort_Last, ToneIndex_SourcePrefix,
ToneIndex_DestinationPrefix, ToneIndex_PriorityIndex;
[\ToneIndex]
For example, the configuration below plays the tone Index #3 to
FXS ports 1 and 2 if the source number prefix of the received
call is 20.
ToneIndex 1 = 1, 2, 20*, , 3;
For more information, see Configuring FXS Distinctive Ringing
and Call Waiting Tones per Source/Destination Number.
Note: The parameter is applicable only to FXS interfaces.
65.10.9.2 Tone Detection Parameters
The signal tone detection parameters are described in the table below.
Table 65-63: Tone Detection Parameters
Parameter Description
DTMF-detector-enable
[DTMFDetectorEnable]
Enables the detection of DTMF signaling.
 [0] = Disable
 [1] = Enable (default)
MFR1-detector-enable
[MFR1DetectorEnable]
Enables the detection of MF-R1 signaling.
 [0] = Disable (default)

[1]
= Enable
[R1DetectionStandard] Determines the MF-R1 protocol used for detection.
 [0] = ITU (default)
 [1] = R1.5
Note: For the parameter to take effect, a device reset is required.
user-defined-tones-detector-
enable
[UserDefinedToneDetectorEnable]
Enables the detection of User Defined Tones signaling,
applicable for Special Information Tone (SIT) detection.
 [0] = Disable (default)
 [1] = Enable