AudioCodes Mediant 1000B - Page 1250

User's Manual 1250 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Parameter Description
Outbound Manipulations Table
Outbound Manipulations
configure voip > sbc manipulation ip-
outbound-manipulation
[IPOutboundManipulation]
Defines outbound manipulation rules.
The format of the ini file table parameter is as follows:
[IPOutboundManipulation]
FORMAT IPOutboundManipulation_Index =
IPOutboundManipulation_ManipulationName,
IPOutboundManipulation_RoutingPolicyName,
IPOutboundManipulation_IsAdditionalManipulation,
IPOutboundManipulation_SrcIPGroupName,
IPOutboundManipulation_DestIPGroupName,
IPOutboundManipulation_SrcUsernamePrefix,
IPOutboundManipulation_SrcHost,
IPOutboundManipulation_DestUsernamePrefix,
IPOutboundManipulation_DestHost,
IPOutboundManipulation_CallingNamePrefix,
IPOutboundManipulation_MessageConditionName,
IPOutboundManipulation_RequestType,
IPOutboundManipulation_ReRouteIPGroupName,
IPOutboundManipulation_Trigger,
IPOutboundManipulation_ManipulatedURI,
IPOutboundManipulation_RemoveFromLeft,
IPOutboundManipulation_RemoveFromRight,
IPOutboundManipulation_LeaveFromRight,
IPOutboundManipulation_Prefix2Add,
IPOutboundManipulation_Suffix2Add,
IPOutboundManipulation_PrivacyRestrictionMode,
IPOutboundManipulation_DestTags,
IPOutboundManipulation_SrcTags;
[\IPOutboundManipulation]
For more information, see ''Configuring IP-to-IP
Outbound Manipulations'' on page 729.
Routing Policies Table
Routing Policies
configure voip > sbc routing sbc-routing-
policy
[SBCRoutingPolicy]
Defines Routing Policies.
The format of the ini file table parameter is as follows:
[SBCRoutingPolicy]
FORMAT SBCRoutingPolicy_Index =
SBCRoutingPolicy_Name,
SBCRoutingPolicy_LCREnable,
SBCRoutingPolicy_LCRAverageCallLength,
SBCRoutingPolicy_LCRDefaultCost,
SBCRoutingPolicy_LdapServerGroupName;
[\SBCRoutingPolicy]
For more information, see ''Configuring SBC Routing
Policy Rules'' on page 715.
Dial Plan Table
Dial Plan
configure voip > sbc dial-plan
[DialPlan]
Defines the name of the Dial Plan.
The format of the ini file table parameter is as follows:
[ DialPlan ]
FORMAT DialPlan_Index = DialPlan_Name;
[ \DialPlan ]
For more information, see ''Configuring Dial Plans'' on