AudioCodes Mediant 1000B - Page 1035

Version 7.2 1035 Mediant 1000B Gateway & E-SBC
User's Manual 65. Configuration Parameters Reference
Parameter Description
dest-ip
[DebugRecordingDestIP]
Debug Recording Destination
Port
configure troubleshoot >
logging settings > dbg-rec-
dest-port
[DebugRecordingDestPort]
Defines the UDP port of the server for capturing debug recording.
The default is 925.
Enable Core Dump
[EnableCoreDump]
Enables the automatic generation of a Core Dump file upon a device
crash.
 [0] Disable (default)
 [1] Enable
Note: For the parameter to take effect, a device reset is required.
Core Dump Destination IP
[CoreDumpDestIP]
Defines the IP address of the remote server where you want the
device to send the Core Dump file.
By default, no IP address is defined.
Logging Filters Table
Logging Filters Table
configure troubleshoot >
logging logging-filters
[LoggingFilters]
The table defines log filtering rules for Syslog messages and debug
recordings.
The format of the ini file table parameter is:
[ LoggingFilters ]
FORMAT LoggingFilters_Index = LoggingFilters_FilterType,
LoggingFilters_Value, LoggingFilters_LogDestination,
LoggingFilters_CaptureType, LoggingFilters_Mode;
[ \LoggingFilters ]
For more information, see ''Configuring Log Filter Rules'' on page
955.
Gateway CDR Format Table
Gateway CDR Format
configure troubleshoot > cdr >
cdr-format gw-cdr-format
[GWCDRFormat]
The table defines CDR customization rules for Gateway calls.
The format of the ini file table parameter is:
[ GWCDRFormat ]
FORMAT GWCDRFormat_Index = GWCDRFormat_CDRType,
GWCDRFormat_FieldType, GWCDRFormat_Title,
GWCDRFormat_RadiusType, GWCDRFormat_RadiusID;
[ \GWCDRFormat ]
For more information, see Customizing CDRs for Gateway Calls on
page 935.
SBC CDR Format Table
SBC CDR Format Table
configure troubleshoot > cdr >
cdr-format sbc-cdr-format
[SBCCDRFormat]
The table defines CDR customization rules for SBC calls.
The format of the ini file table parameter is:
[ SBCCDRFormat ]
FORMAT SBCCDRFormat_Index = SBCCDRFormat_CDRType,
SBCCDRFormat_FieldType, SBCCDRFormat_Title,
SBCCDRFormat_RadiusType, SBCCDRFormat_RadiusID;
[ \SBCCDRFormat ]