Version 7.2 1009 Mediant 1000B Gateway & E-SBC
User's Manual 65. Configuration Parameters Reference
Parameter Description
[1] Enable = (Default) Sending is enabled.
Trap User
trap-user
[SNMPManagerTrapUser_x]
Defines the SNMPv3 USM user or SNMPv2 user to associate
with the trap destination. This determines the trap format,
authentication level, and encryption level. By default, it is
associated with the SNMPv2 user (SNMP trap community
string).
The valid value is a string.
Trap Manager Host Name
manager-host-name
[SNMPTrapManagerHostName]
Defines an FQDN of the remote host used as an SNMP
manager to receive traps sent by the device. The device
sends the traps to the DNS-resolved IP address.
The valid range is a string of up to 99 characters.
For more information, see ''Configuring an SNMP Trap
Destination with FQDN'' on page 97.
Activity Trap
configure troubleshoot > activity-trap
[EnableActivityTrap]
Enables the device to send an SNMP trap to notify of Web
user activities in the Web interface. The activities to report are
configured by the ActivityListToLog parameter.
[0] Disable (default)
[1] Enable
SNMP Community String Parameters
Read Only Community Strings
configure system > snmp settings >
ro-community-string
[SNMPReadOnlyCommunityString_x]
Defines a read-only SNMP community string. Up to five read-
only community strings can be configured.
For more information, see Configuring SNMP Community
Strings on page 93.
Read/Write Community Strings
configure system > snmp settings >
rw-community-string
[SNMPReadWriteCommunityString_x
]
Defines a read-write SNMP community string. Up to five read-
write community strings can be configured.
For more information, see Configuring SNMP Community
Strings on page 93.
Trap Community String
configure system > snmp trap >
community-string
[SNMPTrapCommunityString]
Defines the community string for SNMP traps.
For more information, see Configuring SNMP Community
Strings on page 93.
SNMP Trusted Managers Table
SNMP Trusted Managers
configure system > snmp settings >
trusted-managers
[SNMPTrustedMgr_x]
The table defines up to five IP addresses of remote trusted
SNMP managers from which the SNMP agent accepts and
processes SNMP Get and Set requests.
For more information, see ''Configuring SNMP Trusted
Managers'' on page 97.
SNMP V3 Users Table
SNMP V3 Users
configure system > snmp v3-users
[SNMPUsers]
The table defines SNMP v3 users.
The format of the ini file table parameter is:
[SNMPUsers]
FORMAT SNMPUsers_Index = SNMPUsers_Username,
SNMPUsers_AuthProtocol, SNMPUsers_PrivProtocol,
SNMPUsers_AuthKey, SNMPUsers_PrivKey,
To Next Page
Loading...
