AudioCodes Mediant 1000B - Page 1048

User's Manual 1048 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Parameter Description
[\Authentication]
Where,
 Module = Module number, where 1 denotes the module in Slot
1
 Port = Port number, where 1 denotes the Port 1 of the module
For example:
Authentication 1 = lee,1552,1,2; (user name "lee" with password
1552 for authenticating Port 2 of Module 1)
For a description o this table, see Configuring Authentication on
page 619.
Note: The parameter is applicable only to analog interfaces.
Accounts Table
Accounts
configure voip > sip-definition
account
[Account]
Defines user accounts for registering and/or authenticating
(digest) Trunk Groups or IP Groups (e.g., an IP-PBX) with a
Serving IP Group (e.g., a registrar server).
The format of the ini file table parameter is as follows:
[Account]
FORMAT Account_Index = Account_ServedTrunkGroup,
Account_ServedIPGroupName, Account_ServingIPGroupName,
Account_Username, Account_Password, Account_HostName,
Account_ContactUser, Account_Register,
Account_RegistrarStickiness, Account_RegistrarSearchMode,
Account_RegEventPackageSubscription,
Account_ApplicationType;
[\Account]
For more information, see ''Configuring Registration Accounts'' on
page 383.
Proxy Registration Parameters
Use Default Proxy
configure voip > sip-definition
settings > enable-proxy
[IsProxyUsed]
Enables the use of Proxy Set ID 0 (for backward compatibility).
 [0] No = (Default) Proxy Set 0 is not used.
 [1] Yes = Proxy Set ID 0 is used.
Note:
 The parameter must be used only for backward compatibility.
If not required for backward compatibility, make sure that the
parameter is disabled and use the Proxy Sets table for
configuring all your Proxy Sets (except for Proxy Set ID 0).
 If you are not using a proxy server, you must configure routing
rules to route the call.
 The parameter is applicable only to the Gateway application.
Proxy Name
configure voip > sip-definition
proxy-and-registration > proxy-
name
[ProxyName]
Defines the Home Proxy domain name. If specified, this name is
used as the Request-URI in REGISTER, INVITE and other SIP
messages, and as the host part of the To header in INVITE
messages. If not specified, the Proxy IP address is used instead.
The valid value is a string of up to 49 characters.
Note: The parameter functions together with the
UseProxyIPasHost parameter.
Use Proxy IP as Host
configure voip > sip-definition
Enables the use of the proxy server's IP address (in dotted-
decimal notation) as the host name in SIP From and To headers