AudioCodes Mediant 1000B - Page 1076

User's Manual 1076 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Parameter Description
definition settings > user-
agent-info
[UserAgentDisplayInfo]
<UserAgentDisplayInfo value>/software version' is used, for example:
User-Agent: myproduct/v.7.20A.000.038
If not configured, the default string, <AudioCodes product-
name>/software version' is used, for example:
User-Agent: Audiocodes-Sip-Gateway-Medaint 1000B
Gateway and SBC/v.7.20A.000.038
The maximum string length is 50 characters.
Note: The software version number and preceding forward slash (/)
cannot be modified. Therefore, it is recommended not to include a
forward slash in the parameter's value (to avoid two forward slashes
in the SIP header, which may cause problems).
SDP Session Owner
configure voip > sip-
definition settings > sdp-
session-owner
[SIPSDPSessionOwner]
Defines the value of the Owner line ('o' field) in outgoing SDP
messages.
The valid range is a string of up to 39 characters. The default is
"AudiocodesGW".
For example:
o=AudiocodesGW 1145023829 1145023705 IN IP4
10.33.4.126
Note: For the SBC application, the parameter is applicable only when
the device creates a new SIP message (and SDP) such as when the
device plays a ringback tone. The parameter is not applicable to SIP
messages that the device receives from one end and sends to
another (i.e., does not modify the SDP's 'o' field).
configure voip > sip-
definition settings > sdp-ver-
nego
[EnableSDPVersionNegotiat
ion]
Enables the device to ignore new SDP re-offers (from the media
negotiation perspective) in certain scenarios (such as session
expires). According to RFC 3264, once an SDP session is
established, a new SDP offer is considered a new offer only when the
SDP origin value is incremented. In scenarios such as session
expires, SDP negotiation is irrelevant and thus, the origin field is not
changed.
Even though some SIP devices don’t follow this behavior and don’t
increment the origin value even in scenarios where they want to re-
negotiate, the device can assume that the remote party operates
according to RFC 3264, and in cases where the origin field is not
incremented, the device does not re-negotiate SDP capabilities.
 [0] Disable = (Default) The device negotiates any new SDP re-
offer, regardless of the origin field.
 [1] Enable = The device negotiates only an SDP re-offer with an
incremented origin field.
Subject
configure voip > sip-
definition settings > usr-def-
subject
[SIPSubject]
Defines the Subject header value in outgoing INVITE messages. If not
specified, the Subject header isn't included (default).
The maximum length is up to 50 characters.
configure voip > sip-
definition settings > coder-
priority-nego
[CoderPriorityNegotiation]
Defines the priority for coder negotiation in the incoming SDP offer,
between the device's or remote UA's coder list.
 [0] = (Default) Coder negotiation is given higher priority to the
remote UA's list of supported coders.
 [1] = Coder negotiation is given higher priority to the device's
(local) supported coders list.