User's Manual 1090 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Parameter Description
graceful period ends, the device disconnects all non-idle
channels and then sends out-of-service Service messages to
them.
When connectivity is restored for the Busy
Group is unlocked, the device brings all the trunks back into
service by sending in-service Service messages to all their B-
channels.
[2] D-Channel = (Applicable only to ISDN and fully configured
trunks) Takes the D-channel down or brings it up.
Graceful out-of-service disabled: The device rejects new
incoming calls and immediately takes the D-channel down.
Graceful out-of-service enabled: The device rejects new
incoming calls. Only when all channels are idle (when graceful
period ends or when all channels become idle before graceful
period ends, whichever occurs first), does the device take the
D-channel down.
When connectivity is restored for the Busy Out feature or the Trunk
Group is unlocked, the device brings the D-channels up again.
Note: For partially configured trunks (only some channels
configured), this option only rejects new calls for the trunk; the D-
channel remains up.
[3] Alarm = Sends or clears a PSTN Alarm Indication Signal (AIS)
alarm.
Graceful out-of-service disabled: The device rejects new
incoming calls and immediately sends an AIS alarm.
Graceful out-of-service enabled: The device rejects new
incoming calls and only when all channels are idle (when
graceful period ends or when all channels become idle before
graceful period ends, whichever occurs first), does the device
send an alarm on the trunk.
When connectivity is restored for the Busy Out feature or the Trunk
Group is unlocked, the device clears the alarm.
Note: For partially configured trunks (only some channels
configured), this option only rejects new calls for the trunk; no
alarm is sent.
[4] Block = (Applicable only to CAS) Blocks the B-channels.
Graceful out-of-service disabled: The device rejects new
incoming calls and immediately blocks all channels (idle and
busy). The device disconnects busy channels before blocking
them.
Graceful out-of-service enabled: The device rejects new
incoming calls. If at least one busy channel exists during the
graceful period, the device immediately blocks all idle
channels, and blocks the other B-channels as soon as they
become idle. When graceful period ends, the device
disconnects all non-idle channels and then blocks them.
When connectivity is restored for the Busy Out feature or the Trunk
Group is unlocked, the device unblocks all the B-channels.
[5] Service and D-Channel = (Applicable only to T1 ISDN variants
that support this method) Sends ISDN Service messages to
indicate out-of-service or in-service state and takes the D-channel
down or brings it up.
Graceful out-of-service disabled:
To Next Page
Loading...
