User's Manual 1122 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Parameter Description
Enable SMDI
configure voip > gateway voice-mail-
setting > enable-smdi
[SMDI]
Enables
Simplified Message Desk Interface (SMDI) interface
on the device.
[0] Disable = (Default) Normal serial
[1] Enable (Bellcore)
[2] Ericsson MD-110
[3] NEC (ICS)
Note:
For the parameter to take effect, a device reset is
required.
When the RS-232 connection is used for SMDI
messages (Serial SMDI), it cannot be used for other
applications, for example, to access the Command Line
Interface (CLI).
SMDI Timeout
configure voip > gateway voice-mail-
setting > smdi-timeout-[msec]
[SMDITimeOut]
Defines the time (in msec) that the device waits for an SMDI
Call Status message before or after a Setup message is
received. The parameter synchronizes the SMDI and analog
CAS interfaces.
If the timeout expires and only an SMDI message is
received, the SMDI message is dropped. If the timeout
expires and only a Setup message is received, the call is
established.
The valid range is 0 to 10000 (i.e., 10 seconds). The default
is 2000.
Message Waiting Indication (MWI) Parameters
MWI Off Digit Pattern
configure voip > gateway voice-mail-
setting > mwi-off-dig-ptrn
[MWIOffCode]
Defines the digit code used by the device to notify the PBX
that there are no messages waiting for a specific extension.
This code is added as prefix to the dialed number.
The valid range is a 25-character string.
MWI On Digit Pattern
configure voip > gateway voice-mail-
setting > mwi-on-dig-ptrn
[MWIOnCode]
Defines the digit code used by the device to notify the PBX
of messages waiting for a specific extension. This code is
added as prefix to the dialed number.
The valid range is a 25-character string.
MWI Suffix Pattern
configure voip > gateway voice-mail-
setting > mwi-suffix-pattern
[MWISuffixCode]
Defines the digit code used by the device as a suffix for
'MWI On Digit Pattern' and 'MWI Off Digit Pattern'.
is added to the generated DTMF string after the extension
number.
The valid range is a 25-character string.
MWI Source Number
configure voip > gateway voice-mail-
setting > mwi-source-number
[MWISourceNumber]
Defines the calling party's phone number used in the Q.931
MWI Setup message to PSTN. If not configured, the
channel's phone number is used as the calling number.
configure voip > gateway dtmf-supp-
service supp-service-settings > mwi-
subs-ipgrpid
[MWISubscribeIPGroupID]
Defines the IP Group ID used when subscribing to an MWI
server. The 'The SIP Group Name' field value of the IP
Groups table is used as the Request-URI host name in the
outgoing MWI SIP SUBSCRIBE message. The request is
sent to the IP address defined for the Proxy Set that is
associated with the IP Group. The Proxy Set's capabilities
such as proxy redundancy and load balancing are also
To Next Page
Loading...
