AudioCodes Mediant 1000B - Page 1167

Version 7.2 1167 Mediant 1000B Gateway & E-SBC
User's Manual 65. Configuration Parameters Reference
Parameter Description
(re)initialization, send RESTART if there is no call.
 [67108864] NS ACCEPT ANY CAUSE = Accept any Q.850
Cause IE from ISDN.
Note: This option is applicable only to Euro ISDN.
 [134217728] NS_BRI_DL_ALWAYS_UP (0x08000000) =
By default, the BRI D-channel goes down if there are no
active calls. If this option is configured, the BRI D-
channel is
always up and synchronized.
 [536870912] = Alcatel coding for redirect number and
display name is accepted by the device.
Note: This option is applicable only to QSIG (and relevant
for specific Alcatel PBXs such as OXE).
 [1073741824] QSI ENCODE INTEGER = If this bit is set,
INTEGER ASN.1 type is used in operator coding (compliant
to new ECMA standards); otherwise, OBJECT IDENTIFIER
ASN.1 type is used.
Note: This option is applicable only to QSIG.
 [2147483648]
5ESS National Mode For Bch Maintenance =
Use the National mode of AT&T 5ESS for B-channel
maintenance.
Note:
 To configure the device to support several ISDNIBehavior
features, enter a summation of the individual feat
ure values.
For example, to support both [512] and [2048] features, set
the parameter ISDNIBehavior is set to 2560 (i.e., 512 +
2048).
 When configuring through the Web interface, to select the
options click the arrow button and then for each required
option select 1 to enable.
 For BRI terminal endpoint identifier (TEI) configuration,
instead of using the ISDNIBehavior parameter, use the
following parameters: BriTEIConfigP2P_x,
BriTEIConfigP2MP_x, BriTEIAssignTrigger_x, and
BriTEIRemoveTrigger_x.
[ISDNIBehavior_x] Same as the description for parameter ISDNIBehavior, but for
a specific trunk ID.
General Call Control Behavior
configure voip > interface e1-t1|bri >
isdn-bits-cc-behavior
[ISDNGeneralCCBehavior]
Bit-field for determining several general CC behavior options.
To select the options, click the arrow button, and then for each
required option, select 1 to enable. The default is 0 (i.e.,
disable).
 [2] = Data calls with interworking indication use 64 kbps B-
channels (physical only).
 [8] REVERSE CHAN ALLOC ALGO = Channel ID
allocation algorithm.
 [16] = The device clears down the call if it receives a
NOTIFY message specifying 'User-Suspended'. A NOTIFY
(User-Suspended) message is used by some networks
(e.g., in Italy or Denmark) to indicate that the remote user
has cleared the call, especially in the case of a long
distance voice call.
 [32] CHAN ID 16 ALLOWED = Applies only to ETSI E1
lines (30B+D). Enables handling the differences between