AudioCodes Mediant 1000B - Page 1212

User's Manual 1212 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Parameter Description
Channel Select Mode
ch-select-mode
[ChannelSelectMode]
Defines the method for allocating incoming IP-to-Tel calls to a
channel. The parameter applies to the following:
 All Trunk Groups configured without a channel select mode
in the Trunk Group Settings table (see ''Configuring Trunk
Group Settings'' on page 505).
 All channels and trunks configured without a Trunk Group
ID.
for all Trunk Groups channels that are configured without a
Trunk Group ID,.
 [0] By Dest Phone Number
 [1] Cyclic Ascending (default)
 [2] Ascending
 [3] Cyclic Descending
 [4] Descending
 [5] Dest Number + Cyclic Ascending.
 [6] By Source Phone Number
 [7] Trunk Cyclic Ascending
 [8] Trunk & Channel Cyclic Ascending
 [9] Ring to Hunt Group
 [10] Select Trunk By Supplementary Service Table
 [11] Dest Number + Ascending
For a detailed description of the parameter's options, see
''Configuring Trunk Group Settings'' on page 505.
Default Destination Number
configure voip > gateway dtmf-supp-
service dtmf-and-dialing > ddflt-dest-
nb
[DefaultNumber]
Defines the default destination phone number, which is used if
the received message doesn't contain a called party number
and no phone number is configured in the Trunk Group table
(see Configuring the Trunk Groups on page 503). The
parameter is used as a starting number for the list of channels
comprising all the device's Trunk Groups.
The default is 1000.
Source IP Address Input
configure voip > gateway routing
settings > src-ip-addr-input
[SourceIPAddressInput]
Determines which I
P address the device uses to determine the
source of incoming INVITE messages for IP-to-Tel routing.
 [-1] = (Default) Auto Decision - the parameter is
automatically set to SIP Contact Header (1).
 [0] SIP Contact Header = The IP address in the Contact
header of the incoming INVITE message is used.
 [1] Layer 3 Source IP = The actual IP address (Layer 3)
from where the SIP packet was received is used.
Use Source Number As Display
Name
configure voip > sip-definition
settings > src-nb-as-disp-name
[UseSourceNumberAsDisplayName]
Determines the use of Tel Source Number and Display Name
for Tel-to-IP calls.
 [0]
No = (Default) If a Tel Display Name is received, the Tel
Source Number is used as the IP Source Number and the
Tel Display Name is used as the IP Display Name. If no
Display Name is received from the Tel side, the IP Display
Name remains empty.
 [1] Yes = If a Tel Display Name is received, the Tel Source
Number is used as the IP Source Number and the Tel
Display Name is used as the IP Display Name. If no
Display Name is received from the Tel side, the Tel Source
Number is used as the IP Source Number and also as the