EasyManua.ls Logo

AudioCodes Mediant 1000B - Page 1224

AudioCodes Mediant 1000B
1281 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
User's Manual 1224 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Parameter Description
the redirect reason as received in the Setup message (if none or
“unknown” reason, then without a reason).
[-1] Not Configured = (Default) Received redirect reason is not
changed
[1] Busy = Call forwarding busy
[2] No Reply = Call forwarding no reply
[9] DTE Out of Order = Call forwarding DTE out of order
[10] Deflection = Call deflection
[15] Systematic/Unconditional = Call forward unconditional
Note: The parameter is applicable only to digital interfaces.
Redirect Number IP to Tel
configure voip > gateway
routing settings > redir-nb-si-
2tel
[SetIp2TelRedirectScreeningInd
]
Defines the value of the Redirect Number screening indicator in
ISDN Setup messages.
[-1] Not Configured (default)
[0] User Provided
[1] User Passed
[2] User Failed
[3] Network Provided
Note: The parameter is applicable only to digital interfaces.
Set IP-to-Tel Redirect Reason
configure voip > gateway
manipulation settings > ip2tel-
redir-reason
[SetIp2TelRedirectReason]
Defines the redirect reason for IP-to-Tel calls. If redirect (diversion)
information is received from the IP, the redirect reason is set to the
value of the parameter before the device sends it on to the Tel.
[-1] Not Configured (default)
[0] Unkown
[1] Busy
[2] No Reply
[3] Network Busy
[4] Deflection
[9] DTE out of Order
[10] Forwarding DTE
[13] Transfer
[14] PickUp
[15] Systematic/Unconditional
Note: The parameter is applicable only to digital interfaces.
Set Tel-to-IP Redirect Reason
configure voip > gateway
manipulation settings > tel2ip-
redir-reason
[SetTel2IpRedirectReason]
Defines the redirect reason for Tel-to-IP calls. If redirect (diversion)
information is received from the Tel, the redirect reason is set to
the value of the parameter before the device sends it on to the IP.
[-1] Not Configured (default)
[0] Unkown
[1] Busy
[2] No Reply
[3] Network Busy
[4] Deflection
[9] DTE out of Order
[10] Forwarding DTE
[13] Transfer
[14] PickUp
[15] Systematic/Unconditional

Table of Contents

Other manuals for AudioCodes Mediant 1000B

Related product manuals