AudioCodes Mediant 1000B - Page 1226

User's Manual 1226 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Parameter Description
(IpProfile_CopyDest2RedirectNum). For more information, see
Configuring IP Profiles on page 423.
configure voip > sip-definition
settings > rep-calling-w-redir
[ReplaceCallingWithRedirectNu
mber]
Enables the replacement of the calling number with the redirect
number for ISDN-to-IP calls.
 [0] = Disable (default)
 [1] = The calling name is removed and left blank. The outgoing
INVITE message excludes the redirect number that was used to
replace the calling number. The replacement is done only if a
redirect number is present in the incoming Tel call.
 [2] = Manipulation is done on the new calling party number
(after manipulation of the original calling party number, using the
Tel2IPSourceNumberMappingDialPlanIndex parameter), but
before the regular calling or redirect number manipulation:

If a redirect number exists, it replaces the calling party
number. If there is no redirect number, the calling number is
left unchanged.

If there is a calling “display” name, it remains unchanged.

The redirect number remains unchanged and is included in
the SIP Diversion header.
Note: The parameter is applicable only to digital interfaces.
Add Trunk Group ID as Prefix
configure voip > gateway
routing settings > trkgrpid-prefix
[AddTrunkGroupAsPrefix]
Determines whether the Trunk Group ID is added as a prefix to the
destination phone number (i.e., called number) for Tel-to-IP calls.
 [0] No = (Default) Don't add Trunk Group ID as prefix.
 [1] Yes = Add Trunk Group ID as prefix to called number.
Note:
 This option can be used to define various routing rules.
 To use this feature, you must configure the Trunk Group IDs
(see Configuring Trunk Groups on page 503).
Add Trunk ID as Prefix
configure voip > gateway
routing settings > trk-id-as-
prefix
[AddPortAsPrefix]
Defines if the slot number/port number/Trunk ID is added as a
prefix to the called (destination) number for Tel-to-IP calls.
 [0] No (Default)
 [1] Yes
If enabled, the device adds the following prefix to the called phone
number: slot number (a single digit in the range of 1 to 6) and port
number/Trunk ID (single digit in the range 1 to 8). For example, for
the first trunk/channel located in the first slot, the number "11" is
added as the prefix.
This option can be used to define various routing rules.
Add Trunk Group ID as Prefix to
Source
trkgrpid-pref2source
[AddTrunkGroupAsPrefixToSou
rce]
Determines whether the device adds the Trunk Group ID (from
where the call originated) as the prefix to the calling number (i.e.
source number).
 [0] No (default)
 [1] Yes
Replace Empty Destination with
B-channel Phone Number
configure voip > gateway
routing settings > empty-dst-w-
bch-nb
[ReplaceEmptyDstWithPortNum
Determines whether the internal channel number is used as the
destination number if the called number is missing.
 [0] No (default)
 [1] Yes
Note:

The parameter is applicable only to Tel-to-IP calls and if the