User's Manual 1228 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Parameter Description
RouteModeIP2Tel parameter is set to 0).
Similar operation (of removing the prefix) is also achieved by
using the usual number manipulation rules.
Swap Redirect and Called
Numbers
swap-rdr-n-called-nb
[SwapRedirectNumber]
[0] No = (Default) Don't change numbers.
[1] Yes = Incoming ISDN call that includes a redirect number
(sometimes referred to as 'original called number') uses the
redirect number instead of the called number.
Note: The parameter is applicable only to digital interfaces.
configure voip > gateway
manipulation settings > use-
refer-by-for-calling-num
[UseReferredByForCallingNum
ber]
Determines whether the device uses the number from the URI in
the SIP Referred-By header as the calling number in the outgoing
Q.931 Setup message, when SIP REFER messages are received.
[0] = (Default) No
[1] = Yes
Note:
The parameter is applicable to all ISDN (TBCT, RLT, ECT) and
CAS blind call transfers (except for in-band) and when the
device receives SIP REFER messages with a Referred-By
header.
This manipulation is done before regular IP-to-Tel source
number manipulation.
configure voip > gateway
manipulation settings > swap-
tel-to-ip-phone-num
[SwapTel2IPCalled&CallingNu
mbers]
Global parameter enabling the device to swap the calling and
called numbers received from the Tel side (for Tel-to-IP calls).
You can also configure the functionality per specific calls, using Tel
Profiles (TelProfile_SwapTelToIpPhoneNumbers). For a detailed
description of the parameter and for configuring the functionality in
the Tel Profiles table, see ''Configuring Tel Profiles'' on page 459.
Note: If the functionality is configured for a specific Tel Profile, the
settings of the global parameter is ignored for calls associated with
the Tel Profile.
Add Prefix to Redirect Number
add-pref-to-redir-nb
[Prefix2RedirectNumber]
Defines a string prefix that is added to the Redirect number
received from the Tel side. This prefix is added to the Redirect
Number in the SIP Diversion header.
The valid range is an 8-character string. By default, no value is
defined.
Note: The parameter is applicable only to digital interfaces.
Add Number Plan and Type to
RPI Header
np-n-type-to-rpi-hdr
[AddTON2RPI]
Determines whether the TON/PLAN parameters are included in the
Remote-Party-ID (RPID) header.
[0] No
[1] Yes (default)
If the Remote-Party-ID header is enabled (EnableRPIHeader = 1)
and AddTON2RPI = 1, it's possible to configure the calling and
called number type and number plan using the Number
Manipulation tables for Tel-to-IP calls.
Source Manipulation Mode
configure voip > gateway
routing settings > src-
manipulation
[SourceManipulationMode]
Determines the SIP headers containing the source number after
manipulation:
[0] = (Default) The SIP From and P-Asserted-Identity headers
contain the source number after manipulation.
[1] = Only SIP From header contains the source number after
manipulation, while the P-Asserted-Identity header contains the
To Next Page
Loading...
