Version 7.2 1237 Mediant 1000B Gateway & E-SBC
User's Manual 65. Configuration Parameters Reference
Parameter Description
"user=phone" parameter, the device searches only for
the user part.
Skype Capabilities Header
configure voip > sip-definition settings >
skype-cap-hdr-enable
[DeclareAudcClient]
Enables the device to be identified by an AudioCodes
SBC device as an AudioCodes analog device
deployed in a Microsoft Skype for Business
environment.
[0] Disable (default)
[1] Enable = Upon initial registration (REGISTER
message) of the analog device with the SBC
device, the SBC identifies the analog device as
belonging to AudioCodes and enabled for
operating in the Skype for Business environment.
Once registered, all subsequent calls (i.e., INVITE
messages) received from the analog device or
destined to it are processed by the SBC.
Note: The parameter is applicable only to analog
interfaces.
Handle P-Asserted-Identity
configure voip > sbc settings > p-assert-id
[SBCAssertIdentity]
Global parameter that defines the handling of the SIP
P-Asserted-Identity header. You can also configure
this functionality per specific calls, using IP Profiles
(IpProfile_SBCAssertIdentity). For a detailed
description of the parameter and for configuring this
functionality in the IP Profiles table, see ''Configuring
IP Profiles'' on page 423.
Note: If this functionality is configured for a specific IP
Profile, the settings of this global parameter is ignored
for calls associated with the IP Profile.
Keep original user in Register
configure voip > sbc settings >
keep-contact-user-in-reg
[SBCKeepContactUserinRegister]
Determines whether the device replaces the Contact
user with a unique Contact user in the outgoing
message in response to a REGISTER request.
[0] Disable = (Default) The device replaces the
original Contact user with a unique Contact user,
for example:
Received Contact: <sip:123@domain.com>
Outgoing (unique) Contact:
<sip:FEU1_7_1@SBC>
[1] Enable = The original Contact user is retained
and used in the outgoing REGISTER request.
Note: The parameter is applicable only to REGISTER
messages received from User-type IP Groups and
that are sent to Server-type IP Groups.
SBC Remote Refer Behavior
configure voip > sbc settings > sbc-refer-bhvr
[SBCReferBehavior]
Global parameter that defines the handling of SIP
REFER requests. You can also configure this
functionality per specific calls, using IP Profiles
(IpProfile_SBCRemoteReferBehavior). For a detailed
description of the parameter and for configuring this
functionality in the IP Profiles table, see ''Configuring
IP Profiles'' on page 423.
Note: If this functionality is configured for a specific IP
Profile, the settings of this global parameter is ignored
for calls associated with the IP Profile.
To Next Page
Loading...
