AudioCodes Mediant 1000B - Page 354

User's Manual 354 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Note:
• For the Gateway application: IP Group ID 0 cannot be associated with Proxy Set
ID 0.
• If you delete an IP Group or modify the 'Type' or 'SRD' parameters, the device
immediately terminates currently active calls that are associated with the IP
Group. In addition, all users belonging to the IP Group are removed from the
device's users database.
The following procedure describes how to configure IP Groups through the Web interface.
You can also configure it through ini file (IPGroup) or CLI (configure voip > ip-group).
 To configure an IP Group:
1. Open the IP Groups table (Setup menu > Signaling & Media tab > Core Entities
folder > IP Groups).
2. Click New; the following dialog box appears:
3. Configure an IP Group according to to the parameters described in the table below.
4. Click Apply.
Table 17-6: IP Groups Table Parameter Descriptions
Parameter Description
SRD
srd-name
[IPGroup_SRDName]
Assigns an SRD to the IP Group.
If only one SRD is configured in the SRDs table, the SRD is assigned
by default. If multiple SRDs are configured in the SRDs table, no value
is assigned by default and you must assign one.
To configure SRDs, see Configuring SRDs on page 335.
Note:
 The parameter is mandatory.
 For the parameter to take effect, a device reset is required.
General
Index Defines an index for the new table row.