Version 7.2 363 Mediant 1000B Gateway & E-SBC
User's Manual 17. Control Network
Parameter Description
[IPGroup_CallSetupRulesSe
tId]
classification and manipulation stages).
By default, no value is assigned.
To configure Call Setup Rules, see Configuring Call Setup Rules on
page 393.
Quality of Experience
QoE Profile
qoe-profile
[IPGroup_QOEProfile]
Assigns a Quality of Experience Profile rule.
By default, no value is defined.
To configure Quality of Experience Profiles, see ''Configuring Quality
of Experience Profiles'' on page 315.
Bandwidth Profile
bandwidth-profile
[IPGroup_BWProfile]
Assigns a Bandwidth Profile rule.
By default, no value is defined.
To configure Bandwidth Profiles, see ''Configuring Bandwidth Profiles''
on page 320.
Message Manipulation
Inbound Message
Manipulation Set
inbound-mesg-manipulation-
set
[IPGroup_InboundManSet]
Assigns a Message Manipulation Set (rule) to the IP Group for SIP
message manipulation on the inbound leg.
By default, no value is defined.
To configure Message Manipulation rules, see Configuring SIP
Message Manipulation on page 401.
Note:
The parameter is applicable only to the SBC application.
The IPGroup_SIPGroupName parameter overrides inbound
message manipulation rules (assigned to the
IPGroup_InboundManSet parameter) that manipulate the host
name in Request-URI, To, and/or From SIP headers. If you want to
manipulate the host name using message manipulation rules in any
of these SIP headers, you must apply your manipulation rule
(Manipulation Set ID) to the IP Group as an Outbound Message
Manipulation Set (see the IPGroup_OutboundManSet parameter),
when the IP Group is the destination of the call.
Outbound Message
Manipulation Set
outbound-mesg-
manipulation-set
[IPGroup_OutboundManSet]
Assigns a Message Manipulation Set (rule) to the IP Group for SIP
message manipulation on the outbound leg.
By default, no value is defined.
To configure Message Manipulation rules, see ''Configuring SIP
Message Manipulation'' on page 401.
Note: If you assign a Message Manipulation Set ID that includes rules
for manipulating the host name in the Request-URI, To, and/or From
SIP headers, the parameter overrides the IPGroup_SIPGroupName
parameter.
Message Manipulation User-
Defined String 1
msg-man-user-defined-
string1
[IPGroup_MsgManUserDef1
]
Defines a value for the SIP user part that can be used in Message
Manipulation rules configured in the Message Manipulations table. The
Message Manipulation rule obtains this value from the IP Group, by
using the following syntax:
param.ipg.<src|dst>.user-defined.<0>.
The valid value is a string of up to 30 characters. By default, no value
is defined.
To configure Message Manipulation rules, see ''Configuring SIP
To Next Page
Loading...
