User's Manual 368 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
keep-alive only on the currently active proxy. For Homing-type redundancy, the device
performs keep-alive on the current proxy as well as the "main" proxy. When using SIP
OPTIONS, you can configure the device to consider the proxy as offline if specific SIP
response codes are received from the keep-alive messages. To ensure that a previously
offline proxy is now online, you can configure the number of required consecutive
successful keep-alive messages (SIP OPTIONS only) before the device considers the
proxy as being online. This mechanism avoids the scenario in which the device falsely
detects a proxy as being online when it is actually offline, resulting in call routing failure. To
view the connectivity status of Proxy Sets, see Viewing Proxy Set Status on page 54.3.
You can also enable the device to classify incoming SBC SIP dialogs to IP Groups, based
on Proxy Set. If the source address of the incoming SIP dialog is the same as the address
of a Proxy Set, the device classifies the SIP dialog as belonging to the IP Group that is
associated with the Proxy Set.
To use a configured Proxy Set, you need to assign it to an IP Group in the IP Groups table
(see ''Configuring IP Groups'' on page 353). When the device sends INVITE messages to
an IP Group, it sends it to the address configured for the Proxy Set. You can assign the
same Proxy Set to multiple IP Groups (belonging to the same SRD).
Note:
• It is recommended to classify incoming SIP dialogs to IP Groups, based on the
Classification table (see Configuring Classification Rules on page 687) instead of
based on Proxy Set.
• You can view the device's connectivity status with proxy servers in the Tel-to-IP
Routing table, for Tel-to-IP routing rules whose destination is an IP Group that is
associated with a Proxy Set. The status is only displayed for Proxy Sets enabled
with the Proxy Keep-Alive feature.
The Proxy Set is configured using two tables, one a "child" of the other:
Proxy Sets table: Defines the attributes of the Proxy Set such as associated SIP
Interface and redundancy features - ini file parameter, ProxySet or CLI command,
configure voip > proxy-set
Proxy Set Address table ("child"): Defines the addresses of the Proxy Set - table ini
file parameter, ProxyIP or CLI command, configure voip > proxy-ip > proxy-set-id
To configure a Proxy Set:
1. Open the Proxy Sets table (Setup menu > Signaling & Media tab > Core Entities
folder >Proxy Sets).
To Next Page
Loading...
