AudioCodes Mediant 1000B - Page 506

User's Manual 506 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
3. Configure a Trunk Group according to the parameters described in the table below.
4. Click Apply.
Table 23-2: Trunk Group Settings Table Parameter Descriptions
Parameter Description
General
Index
[TrunkGroupSettings_Index]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Name
trunk-group-name
[TrunkGroupSettings_TrunkGro
upName]
Defines a descriptive name, which is used when associating the
row in other tables.
The valid value can be a string of up to 40 characters. By default,
no name is configured.
The name also represents the Trunk Group in the SIP 'tgrp'
parameter in outgoing INVITE messages (according to RFC 4904)
if the UseSIPtgrp or UseBroadsoftDTG parameter is enabled. For
example, if you configure the parameter to "ITSP-ABC":
sip:+16305550100;tgrp=ITSP-ABC;trunk-
context=+1-630@isp.example.net;user=phone
If the parameter is not configured, the Trunk Group number is used
in the 'tgrp' parameter, for example:
sip:+16305550100;tgrp=TG-1;trunk-context=+1-
630@isp.example.net;user=phone
Note: Each row must be configured with a unique name.
Trunk Group ID
trunk-group-id
[TrunkGroupSettings_TrunkGro
upId]
Defines the Trunk Group ID that you want to configure.
Channel Select Mode
channel-select-mode
[TrunkGroupSettings_ChannelS
electMode]
Defines the method by which IP-to-Tel calls are assigned to the
channels of the Trunk Group.
 [0] By Dest Phone Number = The channel is selected according
to the called (destination) number. If the number is not located,
the call is released. If the channel is unavailable (e.g., busy), the
call is put on call waiting (if call waiting is enabled and no other