User's Manual 526 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
assigned a Cost Group are considered as a higher or lower cost route compared to
other matching routing rules that are assigned Cost Groups. If you disable LCR, the
device ignores the Cost Groups assigned to Tel-to-IP routing rules in the Tel-to-IP
Routing table. LCR is applicable only to Tel-to-IP routing.
The following procedure describes how to configure Routing Policy rules through the Web
interface. You can also configure it through ini file (GwRoutingPolicy) or CLI (configure voip
> gateway routing gw-routing-policy).
To edit the Routing Policy rule:
1. Open the Routing Policies table (Setup menu > Signaling & Media tab > Gateway
folder > Routing > Routing Policies).
2. Click New; the following dialog box appears:
Figure 24-4: Routing Policies Table - Edit Dialog Box
3. Configure the Routing Policy rule according to the parameters described in the table
below.
4. Click Apply.
Table 24-5: Routing Policies Table Parameter Descriptions
Parameter Description
Index
[GwRoutingPolicy_Index]
(Read-only) Displays the index number of the table row.
Name
name
[GWRoutingPolicy_Name]
Defines a descriptive name, which is used when associating the
row in other tables.
The valid value is a string of up to 40 characters. The default
value is "GwRoutingPolicy".
LDAP Servers Group Name
ldap-srv-group-name
[GWRoutingPolicy_LdapServersGr
oupName]
Assigns an LDAP Server Group to the Routing Policy. IP-to-Tel
and Tel-to-IP routing rules that require LDAP-based routing
(and/or Call Setup Rules) use the LDAP server(s) assigned to
the LDAP Server Group.
By default, no value is defined.
For more information on LDAP Server Groups, see ''Configuring
LDAP Server Groups'' on page 242.
LCR Feature Enables the Least Cost Routing (LCR) feature for the Routing
To Next Page
Loading...
