AudioCodes Mediant 1000B - Page 699

Version 7.2 699 Mediant 1000B Gateway & E-SBC
User's Manual 34. Routing SBC
 To configure an IP-to-IP routing rule:
1. Open the IP-to-IP Routing table (Setup menu > Signaling & Media tab > SBC folder
> Routing > IP-to-IP Routing).
2. Click New; the following dialog box appears:
Figure 34-4: IP-to-IP Routing Table - Add Dialog Box
3. Configure an IP-to-IP routing rule according to the parameters described in the table
below.
4. Click Apply.
Table 34-2: IP-to-IP Routing Table Parameter Descriptions
Parameter Description
Routing Policy
sbc-routing-policy-name
[IP2IPRouting_RoutingPolicyName
]
Assigns a Routing Policy to the rule. The Routing Policy
associates the rule with an SRD(s). The Routing Policy also
defines default LCR settings as well as the LDAP servers used
if the routing rule is based on LDAP routing (and Call Setup
Rules).
If only one Routing Policy is configured in the Routing Policies
table, the Routing Policy is automatically assigned. If multiple
Routing Policies are configured, no value is assigned.
To configure Routing Policies, see ''Configuring SBC Routing
Policy Rules'' on page 715.
Note: The parameter is mandatory.
General
Index
[IP2IPRouting_Index]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Name
route-name
Defines a descriptive name, which is used when associating the
row in other tables.