AudioCodes Mediant 1000B - Page 703

Version 7.2 703 Mediant 1000B Gateway & E-SBC
User's Manual 34. Routing SBC
Parameter Description
ReRoute IP Group
re-route-ip-group-id
[IP2IPRouting_ReRouteIPGroupNa
me]
Defines the IP Group that initiated (sent) the SIP redirect
response (e.g., 3xx) or REFER message. This parameter is
typically used for re-routing requests (e.g., INVITEs) when
interworking is required for SIP 3xx redirect responses or
REFER messages. For more information, see ''Interworking SIP
3xx Redirect Responses'' on page 668 and ''Interworking SIP
REFER Messages'' on page 670
, respectively. The parameter
functions together with the 'Call Trigger' parameter (in the table).
The default is Any (i.e., any IP Group).
Note: The selectable IP Group for the parameter depends on
the assigned Routing Policy (in the 'Routing Policy' parameter in
this table). For more information, see ''Configuring SBC Routing
Policy Rules'' on page
715.
Action
Destination Type
dst-type
[IP2IPRouting_DestType]
Determines the destination type to which the outgoing SIP
dialog is sent.
 [0] IP Group = (Default) The SIP dialog is sent to the IP
Group as defined in the 'Destination IP Group'
(IP2IPRouting_DestIPGroupName) parameter. For more
information on the actual address, see the 'Destination IP
Group' parameter.
 [1] Dest Address = The SIP dialog is sent to the address
configured in the following parameters: 'Destination
Address', 'Destination Port' and 'Destination Transport Type'.
 [2] Request URI = The SIP dialog is sent to the address
indicated in the incoming Request-URI. If the parameters
'Destination Port' and 'Destination Transport Type' are
configured, the incoming Request-URI parameters are
overridden and these parameters take precedence.
 [3] ENUM = An ENUM query is sent to include the
destination address. If the parameters 'Destination Port' and
'Destination Transport Type' are configured, the incoming
Request-URI parameters are overridden and these
parameters take precedence.
 [4] Hunt Group = Used for call center survivability. For more
information, see ''Configuring Call Survivability for Call
Centers'' on page 761.
 [5] Dial Plan = (For Backward Compatibility Only - see
Note below) The IP destination is determined by a Dial Plan
index of the loaded Dial Plan file. The syntax of the Dial Plan
index in the Dial Plan file is as follows: <destination / called
prefix number>,0,<IP destination>
Note that the second parameter "0" is ignored. An example
of a configured Dial Plan (# 6) in the Dial Plan file is shown
below:
[ PLAN6 ]
200,0,10.33.8.52 ; called prefix 200 is
routed to destination 10.33.8.52
201,0,10.33.8.52
300,0,itsp.com ; called prefix 300 is
routed to destination itsp.com
Once the Dial Plan is defined, you need to assign it (0 to 7)