User's Manual 706 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Parameter Description
(see ''Configuring the Internal SRV Table'' on page 164).
To terminate SIP OPTIONS messages at the device (i.e., to
handle them locally), set the parameter to "internal".
Destination Port
dst-port
[IP2IPRouting_DestPort]
Defines the destination port to where the call is sent.
Destination Transport Type
dst-transport-type
[IP2IPRouting_DestTransportType]
Defines the transport layer type for sending the call:
[-1] = (Default) Not configured - the transport type is
determined by the SIPTransportType global parameter.
[0] UDP
[1] TCP
TLS
IP Group Set
ipgroupset-name
[IP2IPRouting_IPGroupSetName]
Assigns an IP Group Set to the routing rule. The device routes
the call to one of the IP Groups in the IP Group Set according to
the load-balancing policy configured for the IP Group Set. For
more information, see Configuring IP Group Sets on page 719.
Note: The parameter is applicable only if you configure the
'Destination Type' parameter to IP Group Set (above).
Call Setup Rules Set ID
call-setup-rules-set-id
[IP2IPRouting_CallSetupRulesSetI
d]
Assigns a Call Setup Rule Set ID to the routing rule. The device
performs the Call Setup rules of this Set ID if the incoming call
matches the characteristics of this routing rule. The device
routes the call to the destination according to the routing rule's
configured action, only after it has performed the Call Setup
rules.
To configure Call Setup rules, see ''Configuring Call Setup
Rules'' on page 414.
group-policy
[IP2IPRouting_GroupPolicy]
Defines whether the routing rule includes call forking.
[0] None = (Default) Call uses only this route (ev
Group members are configured in the rows below it).
[1] Forking = Call uses this route and the routes of Forking
Group members, if configured (in the rows below it).
Note: Each Forking Group can contain up to 20 members. In
other words, up to 20 routing rules can be configured for the
same Forking Group.
Cost Group
cost-group
[IP2IPRouting_CostGroup]
Assigns a Cost Group to the routing rule for determining the
cost of the call.
By default, no value is defined.
To configure Cost Groups, see ''Configuring Cost Groups'' on
page 270.
Note:
To implement LCR and its Cost Groups, you must enable
LCR for the Routing Policy assigned to the routing rule (see
''Configuring SBC Routing Policy Rules'' on page 715). If
LCR is disabled, the device ignores the parameter.
The Routing Policy also determines whether matched routing
rules that are not assigned Cost Groups are considered as a
higher or lower cost route compared to matching routing
rules that are assigned Cost Groups. For example, if the
'Default Call Cost' parameter in the Routing Policy is
To Next Page
Loading...
