Version 7.2 819 Mediant 1000B Gateway & E-SBC
User's Manual 45. License Key
To install a License Key file for standalone devices through Web interface:
1. Open the License Key page (see Viewing the License Key on page 815).
6. Back up the currently installed License Key, as a precaution. If the new License Key
does not comply with your requirements, you can re-load this backed-up License Key
to restore the device's original capabilities. For backing up the License Key, see
Backing up the License Key on page 822.
2. Click the Load By File button, navigate to the License Key file on your computer, and
then select the file to load to the device; the Apply New License Key button appears.
The License Key page uses color-coded icons to indicate the changes between the
previous License Key and the newly loaded License Key (for more information, see
Installing License Key through Web Interface on page 816).
Note: If want to cancel installation, reset the device without a save to flash. For more
information, see Resetting the Device on page 777.
7. Click Apply New License Key; the following message box appears:
Figure 45-7: Apply New License Key Message
3. Click Reset; the device begins to save the file to flash memory with a reset and the
following progress message box appears:
Figure 45-8: Reset in Progress for License Key
When installation completes, the following message box appears:
Figure 45-9: Reset and Save-to-Flash Success Message
To Next Page
Loading...
