Version 7.2 83 Mediant 1000B Gateway & E-SBC
User's Manual 6. Web-Based Management
To add IP addresses to the Access List:
1. Open the Access List table (Setup menu > Administration tab > Web & CLI folder >
Access List).
Figure 6-36: Access List - Adding IP Address
2. In the 'Add an authorized IP address' field, configure an IP address, and then click
Add New Entry; the IP address is added to the table.
Figure 6-37: Web & Telnet Access List Table
If you have configured IP addresses in the Access List and you no longer want to restrict
access to the management interface based on the Access List, delete all the IP addresses
in the table, as described in the following procedure.
Note: When deleting all the IP addresses, make sure that you delete the IP address
of the computer from which you are currently logged into the device, last; otherwise,
access from your computer will be immediately denied.
To Next Page
Loading...
